Instantaneous heater or boiler. I wanted to save, and nearly flooded the neighbors

Full "apartment" we began to live a life of 5 years ago. Only then we are faced with the summer off the hot water. While it was not the children, it was bearable. But almost a month to boil water in a pan and basins to wash the children - it is hell.

In the past year we have firmly decided - it is necessary to put a heater. And as an experiment at the time put protochnikWhich once stood in the mother in the village. Almost flooded the apartment itself and its neighbors. It turned out very insidious tool.

This year, nominally set boiler. Water for 5 days as disabled. While normal flight. I think that the model we were not mistaken. Enough to wash themselves and their children, neighbors, we do not flood the device and cost just 4000. But the choice was not easy. I'll tell you about the pros and cons of non-obvious heaters. Possible and useful to you.

density

Clear favorites are small in size instantaneous water heaters. Boiler - it is always a big barrel, which must be somewhere to hide. Now we are doing repairs in the bathroom. Places already little. That's why

inclined towards protochnika until you have tried it in practice.

Digging in Internet and found a model of the boiler, which departs from the wall only 38 cm. She literally stood up very tightly around the risers. We had, of course, finished retreat extra 10 cm from the rear wall of the toilet, but it is tolerable.

power usage

this modest figure conceals in itself the cause of many fires. Power flow heater, which is at least the minimum will be enough for a family - about 7 kW. For its power needs a separate conductor wiring. If the conduct of its copper cable cross-section must be 4 mm2, and the machine in the switchboard 25A. "Hang" this load is not likely to give to a common network.

Small current consumption - another plus in the treasury of our boiler. The model that I found, It calculated only 1.2 kW, but heats the water for the whole family. I even did not lead outlet of the meter.

The whole truth about the heating temperature

It is here that we are "burned" last summer. This is not even about the parameters declared by the manufacturer. To heat the water heater can heat up to 650 degrees. In a boiler it is at a high capacity and water takes all temperatures. In flow-through water heaters otherwise.

I do not know why, but our model flow heater is a mini boiler - it was a drive of about 500 ml. After 5 minutes after each dishwashing, kitchen there was a strange noise - hissing water flowed from the ruptured hose.

I quickly cut off the water and began to understand. Before pipe near the heater could not be touched. Temperature thin burst hose on the filter drinking water. I believe that the internal volume of the water can not fully repay the heating element the heating temperature, therefore, Grelle all around and it came to the accident.

Price

Boilers are much more expensive instantaneous water heaters. Most of the price affects the volume of the tank, but there are other factors. Internet climbed up and down, I I found a model Ariston ABS BLU R 40 V. It cost me only 4000, although equipment costs at the level of its more expensive competitors. If you know of any other worthy models of boilers, write in comments.

On this I have everything. Thank you for reading the text to the end!