Useful content

A clever way to wall cladding with plasterboard

click fraud protection

Sheet of drywall - a very convenient and practical building material for the equalization curves walls and ceilings in the house or apartment. Ease material that its mounting absolutely requires no special knowledge, the most important thing - to observe the technology, which will be discussed in this article.

Preparation of material and tools

First stage - examination wall measured deviations from the vertical / horizontal and selection of the appropriate way of fastening sheets of drywall.

Good news: if the deviation of the wall less than 20 mmThen you can easily glue the drywall sheets on the wall with a leveling of the small block or other sheets of drywall.

If the wall deviates from the vertical / horizontal more than 20 mm, Will have to make the frame and plasterboard sheets to be attached to it already.

The frame can be built in two materials:

  • wooden blocks;
  • metal profiles

In both cases, to fasten drywall used Shura (screwdriver) and galvanized screws.

What if the walls of the deviation of less than 2 cm?

instagram viewer

As mentioned above, you can put the drywall sheets in the glue. The main condition - good adhesion (coupling). To provide it, the wall is necessary to remove dust. If the walls are plastered - make sure that it clings to the wall if there is a problem - refurbish plaster layer.

And if suddenly the paint on the wall there - grab a chisel and take on the paint horizontal and vertical incisions 10 and 30 centimeters, respectively.

What if the walls of the deviation of more than 2 cm?

In this case, the curvature of the walls you will save the frame, but it will have to tinker.

The main rule - to build a framework in strict accordance with in the vertical. Special metal rails with adjustable bolts help expose frame accurate.

Important: The ideal spacing between hangers - 40 - 60 cm. The guide profile is fixed with screws at intervals of 1 meter.

To facilitate the installation of the plates after you have assembled frame - cut drywall sheets to the necessary pieces using a knife stationery.

Important: Recessed cap screws to gypsum (so they are not stuck and did not spoil the wall space).

The recesses, and then seams are masked by a layer of putty.

Testing of the world's first battery-powered locomotive begins in California

Testing of the world's first battery-powered locomotive begins in California

In the state of California (USA), a battery locomotive test has started on the most common regula...

Read More

Rare Higgs boson decay discovered at the Large Hadron Collider

Rare Higgs boson decay discovered at the Large Hadron Collider

For the first time, the Higgs boson was actively talked about in the world scientific community b...

Read More

The effectiveness of the perovskite panels was increased by the addition of the main component of chili pepper

The effectiveness of the perovskite panels was increased by the addition of the main component of chili pepper

The addition of hot chili peppers will make any dish sparkle with new colors. But as it turned ou...

Read More

Instagram story viewer