Water purification from iron in the country with their own hands

In the last article we looked at the issue of competent diversion of water from the well for chemical analysis in the laboratory, and now we talk about ways

Pump stopped pumping water from a well, why? Replies can be several: the walls fell ferruginous sediments and filter clean. At the same time, if you do not have enough money to buy the right for iron removal equipment, it can be done with your own hands!

Driving the creation of the aeration system is as follows:

• Needed plastic tank 1 with a bottom as in barrel
• PVC pipe
• Spray.

On the attic floor of the house or attic mounted plastic storage tank (it does not rust). To the tank are fed water supply pipes: the first pipe connects the tank, well and pump, just for her water enters the tank.

ImportantTo the first pipe has passed across the tank and finished spray. If you did not purchase the spray, it is possible to do small holes in its end, and install the plug.

This creates a drain system, which provides water drainage thin streams and ensure water saturation with air, from which pereodet divalent iron to trivalent and precipitates.

The second tube is attached to the tank from the opposite side at a height of 20 cm from the bottom of the tank. After the oxidation reaction, iron precipitates, and sink to the bottom of the tank, and the system goes home purified water.

Such an arrangement has its advantages:

• Efficiency;
• It does not require a lot of attention: it is necessary to monitor the state of a nebulizer or punching holes in his absence;
• Easily repaired;
• Cheap to build.