Installation of PVC windows. 5 Repair of bridges over an aperture
As it turns out, will not insert a new window until it is restored to beat during the entire length window lintel. Apparently, she made errors, because the same are beams throughout the house and almost all integers (even pictured neighbor's seen whole).
Third floor, but still work required the utmost caution.
It took posbivat pootkovyrivat and all that was cracked and could just about pootvalivatsya. And had to be partially cleaned the underside of the bridge from the old Kleve whitewash. All did not rip off at 100%, as planned laterpolystyrene insulation slope.
The solution for the closing of cracks decided to make the remainder from the previous object adhesive mixture for the tile 11 CM. By itself, it is for the plastering is not very suitable, because the naughty and hard - a thick layer will not do as floats. To facilitate the work, he added a bit of glue finishing putty. The ratio came about 10:1.
Ideally, the first coat is diluted in water and then it is poured gypsum jelly glue. Work ready to make possible about 20 minutes Then he strongly thickens. Add water to mix and can be, but the mixture is unlikely to fall asleep quickly, that was the main thing for me.
After application of the 1st layer was view bridge such as Picture 4.
I worked spatulas. Gloss over accounted for almost the entire front portion except the sidewall of the upper lip. Above the entire length of the jumper protrusion longitudinal crack wasThrough which water flows inside and gradually destroyed it. To overcome this drawback the solution had to score and make a crack Bevel 30 degrees.
Across 20 minutes a first layer of filler by adding a little "podmerz" so almost without interruption was held spatula on jumper once more, this time using a less dense solution. The second time the problem was just a little trim. Special aesthetic problems did not put as perhaps later this season or the next will bring everything to mind, along with the warming of the slope. Well andFurther, finally, installation of a new frame.
Evaluate material andsign upCanal.
ANDit is interesting:
Installing PVC windows inside and out. №1 screwed handle
Installation of PVC windows. Remove flap № 2
Installation of PVC windows. How to pull №3 glazing beads and glazing