Maybe the oil was? Replacing the cartridge in the filter in the kitchen at 6 months

At this time, a report from the village. I went to my parents, where once again have to replace the filter cartridge rough water purification, which serves the kitchen and bathroom with stiralka. Last time it was 6 months ago.

Even in appearance, it was clear that the clogging of the filter complete, but the whole point was opened after disassembly. So...

1. After the overlap of the water tap in the filter, which is located right on its input, and the depressurization by opening the faucet in the sink, I found a special wrench to unscrew the bulb. He was complete with bulb, so if there is a filter, and the key is usually too.

I put the key in the bulb and cranked lugs firmly. Twisted bulb well, so it is necessary to keep the top cover with the other hand.

With otkruchennoy flask with the water poured black rags, and when the finger touched the extractable filter, it seemed that in the top layer forming the cord cartridge is nothing as soot! Until the end of the day to wash your fingers properly and could not - velos thoroughly.

The water in these parts is known for excess hydrogen sulfide. Rarely, but sometimes that does not flow out of the pipe is transparent, and it is literally black water, like oil. Gray and her dusky hue - the norm. After 10-30 minutes, the water completely clarified, and the smell of hydrogen sulfide, reminiscent of rotten eggs, completely disappears the next day and the taste of the water FIHM excellent.

I had to spend another 15-20 minutes to wash the flask on a dark coating. I did this ancient kitchen Yorshik. Almost all of the dirt left behind, just at the bottom of a little left, where the surface is uneven and the projections interfere.

I almost forgot to clean and wash the cover, which is screwed into the bulb. I am doing it right in the nightstand, as shoot it - the whole affair.

I charge the new cartridge. Previously, it seems, on the cartridge was clear The thin plastic ring for his ottsentrovki, but this time did not find it. The cartridge was in the middle, made of wire ring spacers in three points. Her two horns can be seen in the picture 4. Although not required, but it did.

Also does not hurt to check the condition of the sealing ring, which is located at the end of the flask in a special groove (photo 5). It should be removed, washed and checked for integrity. Usually it is because of his wrong position or poor thread tightening the bulb dripping water, so then when you reinstall the cartridge should be especially careful.

The new cartridge is in place with a rubber ring order, can be screwed into place flask. First, I twist the hand, and hold out the key, which can be seen on photo 1. I turn tap and stating the fact successful replacement cartridge. A few months later - all over again!

Evaluate material andsign upCanal.

ANDit is interesting:

Still it! Cleverly zapenil pipe in the ceiling of

Clean trap pan. Complete blockage of some 7 months

Closing unsightly outputs pipe lining of plastic