Insulation of the outer slope polystyrene apartment. Part 2

You've got to Continuing the theme of the slope of the outer insulation in the apartment from which the beginning can be found here - Part 1And then come back here. Topic is relevant for all buildings made of stone, bricks, tiles, concrete blocks and etc.

Let me remind you that all the preparatory work has been completed, it remains to glue polystyrene and perform reinforcing finish.

I continue to deal with the preparation of glue mixture. The same material is used for reinforcement of polystyrene from above. I do not thick mixtureTo be able to pin down and pristuchat strip to the slope and so to fill small irregularities.

Friends that missed to do is to take a trowel for leveling the mixture of the bands, and also for this reason, do not mix thick.

Pasting first upper strip and cut out a piece of it missing, then fining side flanks, starting from the bottom of the low tide, under which were previously provided cut-outs and also insert missing pieces.

The result is that the lateral strips bear against the top and additionally it prop.

IMPORTANT! I do not wait until it has adhered to the slope polystyrene, and immediately begin its external finish.

Nanoshu trowel 15 cm wide adhesive thin layer on one side, leveling it to the expanded polystyrene and the top to smooth reinforcing mesh, which is also already sliced. On photo 4 It is seen that the grid almost reaches the outer edge of the strip that is made specifically for easier plastering. Thereafter, over the mesh immediately nanoshu another layer of the mixture and is smoothed so that the mesh was not visible. The same repeat with the other parties.

If the grid strips along the length shorter than required, you must add the missing piece of an overlap of 3-5 cm.

When the windows on the first floor, at the corners additionally pasting the corners, but here the 2nd floor.

As can be seen on shot 5, Slope basically ready. Just clean up after drying, there is not much. The ends of the polystyrene foam strips do not protrude beyond the plane of the wall and also smeared. In this capital of the insulation slope completed.

This slope can be left as is or paint the facade paint. Even in unpainted form of rain and frost is not afraid.

And if you want to make it absolutely beautifully, after drying, it can be even putty finishing putty for exterior, Dried, sanded and only then paint. A matter of taste, in general.

Evaluate material andsign upCanal.

ANDit is interesting:

Insulation of the outer slope polystyrene apartment. Part 1

I eliminated the tiles on the wall - glue. The reason for the unusual

Why put a flexible liner made of PVC instead of stainless steel