Useful content

Hacksaw tricky wiring pliers

click fraud protection
Picture 1.
Picture 1.

Each case begins with the selection tool. To perform wiring tooth hacksaw, I decided only to use pliers. Yes, only them, but before the tool case for convenience had slightly improved. How to do this thought did not last long, so you probably tell me better ways to layout. But stop until their fiction.

And I have done without clutches, although with them, of course, it would be more convenient.
Picture 2.
Picture 2.

The first thing done longitudinal jaws propyl grinder to a depth of about 1 cm. This point is best to choose the experimental, focusing on the tooth length.

A little bit later Stoch sponges plane to an acute angle (Photo 2). So that in the closed state of the side faces of the jaws, after the installation of the kerf on any tooth, rested on the adjacent teeth of the right and left from captured (photo 3). bending tool is ready!

Picture 3.
Picture 3.

The first pass through one peels back teeth with the right grinding and then to the left.

Bending can be directly in the hands or putting a hacksaw on the plane. I tried and so it turned out fine.
instagram viewer

Note that with such wiring load distributed is not linear, in two directions. This helps to avoid the fracture of teeth, although one I still broke off - rzhavenky caught. But since this saw another mammoth walk, then not much pity.

Picture 4.
Picture 4.

After the passage of one and the other side of diluted fabric looks like, as in the photo 4 - the sense will be.

However, this is only half the battle. Although after wiring handsaw sawing already better, I decided to still further erode teeth grinder, which is read in the short article.

Evaluate material andsign upCanal.

ANDit is interesting:

How else to protect inexpensive wallpaper? corners only
Painting the walls at once. doable
Easy removal of old varnish. And with furniture can
Sorry for grandfather, staged a miracle mixer. Do not fall
How to make my heat exchanger hermetic (condensate drain, sealant gaskets...)? I continue my experiment, the result is in the face.

How to make my heat exchanger hermetic (condensate drain, sealant gaskets...)? I continue my experiment, the result is in the face.

If you have already begun to "sculpt" everything from improvised means, and various remnants, the...

Read More

No need to wait for "uncle". Replaced hooks in dentistry. Surprised 1 moment

No need to wait for "uncle". Replaced hooks in dentistry. Surprised 1 moment

He treated his teeth in our Crimean polyclinic, everything seems to be as usual. The dentistry de...

Read More

I calculated the income from the garden and thought... Is it worth it?

I calculated the income from the garden and thought... Is it worth it?

We only have a small vegetable garden near the house, five or six hundred square meters. We plant...

Read More

Instagram story viewer