6 more ideas to replace the handles mosquito nets
Thanks to you, dear subscribers and readers turned to collect even a handful of ideas for replacement flown away handles on a mosquito net, and that share.
So I will continue the theme of the article "3 a method for replacing a mosquito net pens. Simply nowhere!", which mentioned only the most simple variants improvised pens. And here I will touch others, including a little more advanced, but not less than practical methods for their manufacture and installation.
Among the simple
Read the comments and said that ingenuity has no borders, so the show only some of your and your already used by many "technology." first - Pen-clip. The truth here caution is needed that would be the most staple not damage the grid, especially if it is already several years old.
And the clip, as you see may be different, but the thread the little bit easier, although it creates a bit of a heavy load on the grid during installation.
Pens with self-tapping fixing
Metal mesh on the frame easily drilled, but even if there is a drill, it is possible to dig up an awl and firmly screwed into the screw.
On some models put moskitok metal fasteners for fixing the inside mesh. Them or like them Circuits can be used as handles. If such fixtures much, a couple of them I fit under here are the pens.
As a material for handles I liked the plastic from under jars, which was cream; it is flexible, it does not crack and can be cut with scissors. In the first case (Photo 4)arcuate cut strip done on hole edges, folded into a loop and a light softwood "bug" with a drill at the tip (and other suitable length of 10 mm).We must look to the size of the loop does not interfere with installation of the grid and it is not limited by the frame.
strip an arc easier to deliver, so it after folding in the loop makes it easy to tighten the screw with a screwdriver.
Another handle cut from cover jars (photo 5a). Again, you need to to monitor the height of the workpieceThat at the close of the window frame is not squeezed net.
Cut out a strip of plastic 6-8 cm longHe folded it in half and attach to the frame, was very easy to handle gizmo (Picture 5b).
This handle is very flexible, accurate, and will not interfere, because the plastic is soft, allowing themselves to squeeze in a loop and straighten .
And finally, perhaps the most complex version of the handle - it is cut from the wall of the very essential banks. The handle itself is slightly turned in up, because he so bent plastic that had to come in handy.
The shape of the handle is made of taste and the size of fingers. One screw for fixing it quite enough, but the second does not hurt.
Hopefully this collection proved to be useful, and perhaps prompted for new ideas. Share them in the comments and when I will gather new collection, write again.
Evaluate material andsign upCanal.
And it is interesting:
The movable plug sockets for your own hands
Jammed ball valves. Close slowly
RJ45 connector replaced without special tools