The adhesive method of installation of wall panels

To secure the wall panels on the basis of quality work, you can use different methods. Among those that allow the maximum to preserve the useful area of ​​the room, it is worth noting the adhesive. What is peculiar to such a method and exactly how it is implemented in practice? About it and discussed below.

The main features of the method the adhesive

As above mentioned, and the advantage of this approach is that it saves valuable space. After all, when placing wall panels using adhesive thickness of finishing out not too large. At the same time, she is not very bulky casing, weighs little.

Only thing that initially the wall panels are light. Thus, the adhesive can be laid products made of PVC, MDF or OSB. Heavier and robust options panel it is better to fix the other methods. And keep in mind that this type of complexity is possible. To avoid them, you should become more closely acquainted with the procedure.

How to style the wall panels on the glue

1. Preparation of the work surface. To secure the wall panels will first need to remove the previous finish. In the presence of old wallpaper or layer of a spray adhesive composition can not reliably fix a new finish. You also need to bring down the plaster falls off because it will still eventually move away from the surface with panels themselves.

2. Rough alignment. Wall panels can reliably be fixed only if the rough base is flat, completely devoid of height differences. Therefore, also in the preparatory stage it is necessary to rough alignment. For this purpose, the surface coating is applied, and then - a new plaster. When the walls are aligned, they are primed again.

3. Bonding wall panels. In most cases, the panel is placed vertically. The procedure itself is that the adhesive composition is applied to a section of the wall, and then laid panel, it is required to align and squeezed so that surplus adhesive are out of the material. Adjacent panels additional combine via Paso-ridge system. As a result, plating is formed, in which no through-slits, which greatly increases the functionality and enhances its appearance.

As you can see, the problems in the implementation of this method is still enough. But if we consider all represent a specific character, just be able to create a solid finish.