Sticking wallpaper. Why not hit the drawing, although the joint is correct? Master OK
I am glad to greet you on the canal! Today I will share why had to glue a strip of expensive wallpaper, though seemingly did everything right: joint dense pattern is matched, the air under no wallpaper. But...
Figure it does not match!
Yes, the incident jumped unexpectedly. All because the power is not calculated during the docking yesterday and today's web. From the ceiling to the middle of the wall drawing coincided completely, but went to the bottom of the Extension, which is on the floor increased to 0.5-0.7 cm (watch this video at end of article). And the reasons for this has seen a few:
- 1. Strong stretch fabric. Since working plastic spatula, staring clamping movement downward from the ceiling creates small stretching, which gradually transformed into a picture and the offset becomes significant below middle.
- 2. Soaking glue. The instructions for this type of wallpaper clearly spelled out that the web is pressed against the wall, you need to immediately after the application of glue on it. And as a wall still not prepared, part of the glue soon she simply "eats" and if you wait for 10-15 minutes, then it is necessary to spread again. So, working with a pause after smearing the walls, wallpaper cling worse and you have a spatula push them stronger - and thus to stretch more!
- 3. The weight of the web. Non-woven wallpaper considered heavy, so a little bit and stretch under its own weight, especially if the fabric with glue, for some reason, long hanging and not cleave into place.
- 4. Docking canvases glued at different times. When fresh strips are easy to shift relative to each other, and if one has dried up, you can move only one and a limited height, otherwise will fold.
What is the way out
While the wallpaper was dry, eliminating the offset pattern is not difficult. Me in these moments rescues the following:
- Completely break away from the damp walls of the piece and once again put on his place of glue.
- The upper portion of the web slightly presses against the wall so as not to fall. This is a temporary measure.
- I combine pattern in the middle of the strip to the adjacent web and gradually begins to smooth with little effort from the middle of the up and down. So if the offset and appear to find it difficult.
Here, please take a look at a revised version of the interface, which is the first photo came out of place (photo 4). There was all well and went to work on the peaceful manner.
And here I show how svol the other two on the bottom of the strip in accurate register. It is the lower part of the joint shows how well glued solid stripe. There remained only the butt end to straighten up.
So, the main thing to notice gaga drawing and all corrected without sad aesthetic consequences. So again, everything is OK!
Put your article assessment, and share your thoughts in the comments. Layknite the heart and sign up per channel, so as not to miss much more useful!
Read more:
Ceiling plinth glue to wallpaper or after? Master OK
And nice cat: ventilation doors in the bathroom
remote control buttons do not work? 15 minutes and everything is OK!
Walls - fear, wallpaper - Wah! What came of it? Master OK
Slopes tiles in the bathroom. Rate it!