How to align the slope perforated corners

Those interested in Installed window trimI want to please the forthcoming phased process, which began with the preparation of a surface leveling and gluing parts. On the preparation does not stop, except to say that all scraped peel, trimmed slope ax and primed. After that turn to the glueing of perforated PVC corners.

check the level

Before the start of gluing level determines how smooth the angles on the slope to see if somewhere apply layer of putty you need more (Photo 1). As seen from the photo, the top right escarpment inundated, so here the layer start will thicker.

Apply the mixture

Kneaded putty nanoshu starting from the corner to the side. First completely pass one way, then another. In this case, I try to excess as small as possible. Toward the corner of the overlay layer or going from top to bottom evenly does not work, especially if at a certain portion of the thickness have to add.

Puts pre-cut area, and a little dent in its putty. Strongly crushing is not necessary, because, perhaps, a corner will have to align, by placing it under the plaster in places of depressions. Again, check the vertical

bubble level and when convinced that everything is in order, starting at the corner apply putty.

Flatten the material should be such that in the first place, he filled all the perforations in the corner and plastered inside it turned into a monolith. PVC Corner for such work is considered more appropriate than aluminumSince it is not exactly eat corrosion. But aluminum angle may deteriorate after a couple of years, especially if the holes were Stopper bad and the room is often humid.

On either side of the corner of the slope plane of the wall and at this stage is not particularly touch and far they do not come. Typically, more than 10 cm is not captured, allowing you to focus precisely on the corners and their alignment.

After hardening putty corners become guiding beacon, which will be plastered and the whole plane of the slope.

On the other work too soon I write.

Evaluate material andsign upCanal.

ANDit is interesting:

Warming slope on polystyrene foam

As far as the thick metal drill screw for 50 cents

How to drill tile and brick softwood