How to drill tile and brick screws. Result

Normally, ceramic tiles dowel drilled with a drill pobeditovym carbide tip or tip diamond-coated. I decided to move away from the standard and try to make a hole screws, not only the most common wood, but with pressshayboy, On whose tip has a small sverlyshko. These screws can easily pass through the sheet metal, they are mounted sections, so I thought that must cope with ceramics.

Available were pressshayboy screws with a length of 35 or 40 mm, And they worked.

Hat a bit off the screw pliers. A screw bitten off to the best kept in the cartridge and does not slip, that is, on top of the thread that is clamped collet chuck, on coils wound a piece of thin aluminum wires. Although she could not do, but more reliable.

Tile used a good, 7 mm thick. This is not the granite of course, but still. Marker even drew a conditional place drill and tried to get it into the center of the cross. As it turned out, the tip does not slide and is quite easy to hit the target. In trick through hole it took about 30 seconds

instagram viewer

or even less. And it is a low speed electric screwdriver.

The picture shows how the result turned out to be boring. The edges of the holes quite flat, small chips are, but it's not scary, because this hole still needs to be expanded.

Typically, such small-diameter hole, how is rarely needed, so try to increase it, and also without the use of drills pobeditovye. The most popular standard holes - 5-6 mm, From what and repelled by choosing option for further drilling. Of the several drills of old chose one on 6 mm and I tried to go through the already drilled more tiles and him.

Whistle, however, was small at first, but when moistened with water hole, things got quieter and faster. Re-drill the tile could also somewhere for half a minute, and the result is once again pleased. And the edge of the enlarged hole on the front side turned out just perfect. Bottom formed small chips around, but it's due to the fact that the tiles lay on the tree, and if it were on the wall, the bottom and everything would be fine.

And I tried the same self-tapping drill-lime brick and also all work out. The drill went down to the full depth. If a tile wall made of silicate, the non-stop, and it is possible to drill and then drill in a hole and expand larger in the tile and brick.

I liked the way. And it is not a difficult. So, my friends, keep in mind this possibility and place their assessment described idea.

Evaluate material andsign upCanal.

ANDit is interesting: