Installation of PVC windows. 6 and zapenivaem frame Fasten

Still, it came to the installation new PVC joinery. For those who came to my blog for the first time to say that before were considered all Preliminary steps for installing windows, Including the dismantling of the glazing and the dismantling of the old windows. So, just find these materials.

Go

Installation begins with fixing the mounting metal plates. However, if the bottom of the frame is not screwed DIN rail PVC, You should start with it (I have brought in the form of screwed).

plates 6 items and they are included in the packaging box.

Markings and alignment

Before screwing the frame plates to the opening and put a pencil mark the spot for 3 mounting on the right and left. Tags set so that the fasteners on the wall did not fall in the masonry joints (Photo 2).

According to the frame to enclose wedges and exhibited on the level. It was necessary to take into account that the frame has become symmetrically on the sides and top. Bottom, and then the situation can be slightly adjusted.

Fasten the mounting rail and plate

IMPORTANT! Included with the window there is always a mounting bar (rail) of plastic. I have it dark gray and it can be seen in photo 2. This piece is cut and fastened to the frame from the bottom screws in advance. Later it will rest against the sill.

tie metal plate the frame is worth based on the conditions at the place of installation. In this case, the plates are bolted to the side of the street, but first wanted to put the other way around. holes had done a drill for metal 2 mm. It has a metal profile inside the frame, so a simple screw it would be difficult to screw in. However, when there is at hand 15-25 mm screw and drill pressshayboy on the tip, the individual drill is no longer needed.

Mounting in the opening frame

For fixing the frame to the wall took dowels 8 mm and yellow screws under them 60 mm. Place on a plate and drilling point on the wall is chosen so that after screwing the screw plate was a little stretch. Under this condition, the frame is securely held even without foaming and rest trim. On top of any fasteners not set because the window size is small.

More often plates have to be fixed to the slope itself, and well, if this is done without any backlash.

frame foaming

Foaming preceded by thorough wetting and water brick frame with a spray. It is better to do it repeatedly, you can even go along. Water greatly improves adhesion (coupling) foam a wall that does not allow it to fall down after application.

The foam is applied in two passes starting from the top. First I try as much as possible inside zapenit frame abutting against the outer wall. After a short delay (15-30 minutes) when the first foam cushion grip, again sprinkled with water and was derailed perimeter foam again. Places where the inserted wedges zapenival later, when all the foam is dry and can be pulled out.

Foam inflicted in such a way that for finishing in the slope will be even pasted pieces of foam. If done without it, the cavity zapenil more.

Perhaps, with the installation of the frame it! Now turn the tide of the sill and, as soon necessarily tell.

Evaluate material andsign upCanal.

ANDit is interesting:

Installation of PVC windows. №5 Repairs bridge over an opening

Installation of PVC windows. Remove flap № 2

Installation of PVC windows. How to pull №3 glazing beads and glazing