Installation of PVC windows. Remove the sash 2
it second Article series on installing plastic window.
As planned, in order to reduce the weight of the window, we had to remove him from opening the flap, which previously took set the knobfrom the set of fittings. The following are the details of the work of dismantling the leaf.
The main task - pull the plug pin from the upper canopy.
inserted pin usually below. And it can be put on top, of course, but then, if necessary, remove the leaf with an already inserted windows You have to disassemble or break the upper slope, since it will not pull the pin up on all his length.
So, press down on the top edge of the pin with a screwdriver and it goes down a little bit (photo 2). And then it can have bottom or your fingers to pull the pliers.
when lowered stop pin to hold the sash the top of it can be a little pull over, so it was convenient to take on both sides. Tilting sash to her, getting traffic, similar to the installation of windows in ventilation. With this state of the flap is lifted up just 5 cm and fully rented as well as doors with awnings.
Bottom at the same time not to touch anything you need, as there stands a movable short pin on the bottom of which is provided for connection to the frame.
Thus, the left side of the frame is already free, but now more need pull glazing on the right side, which I will describe in the next post.
Evaluate material andsign upCanal.
ANDit is interesting:
Installing PVC windows inside and out. №1 screwed handle
Replacing the crane Majewski on the ball in the radiator. We prepare the system for the winter
Repair stools in a new way