The mask of plastic bottles from dust for 5 minutes. For grinders, cutting grooves, ceilings

This is the case when the goggles are inconvenient, mist, broken or simply not there. Protective mask from a plastic bottle really easy to use and works better than other protective special equipment, just a bottle should be smooth, clear and bright.

The necessary tools and materials included very little: PVC bottle of 2 liters, gum 20-25 cm wide, the strip of self-adhesive foam 50cm (I tape from drafts), Knife, office stapler, scissors.

Preparation of starting base mask trimming top and bottom of the bottle to get a smooth cylinder. To do this, use kitchen scissors. The edges can be accurately trim later.

Now the resulting plastic cylinder cut longitudinally and rolled to obtain a sheet of plastic pipe. Unfolding it, cut the two lower edge a semicircleTo the future mask does not cut corners when using the neck.

Finally to round the edges as desired, you can already after the final fitting.

To the top, not the rounded edges on the outside I am attaching stapler gum in several points. Gum select the size of the head, and its width - to taste. Wide to strengthen much more convenient. Staples are normally plastic and hold well for him. More check and, if necessary, bends the ends of the staples, so you do not scratch your head.

At the end of the upper edge of plastic, over the entire length, sizing of a strip seal. Would be self-adhesive foam would use it, and so in the course went sealing tape from drafts. She, too soft, hollow inside and lie down a well-to-head.

Tape is needed to prevent dust from getting on top of the eye and not glass beads of sweat.

And here is the finished mask that remains to verify in fact, going to the dusty room or picking up a grinder. I was such a thing really helps when stripping the old ceiling of lime, cut brick walls and shtroblenie.

New guard easily rolled into a tube and fits in any pocket tool belt or bag. In the manufacture of masks it took about 5-6 minutes. And as it was, see in the video.

Evaluate material andsign upCanal.

ANDit is interesting:

How to enable European plug socket in the Soviet without an adapter

A friend suggested: sharpening drills without special tools

German silver cleaning water and a sponge. And why do something else?