A container for drill and any fines from the PVC pipe residues

Since the previous blog articles have been devoted to working with PVC pipes on the same wave of unnecessary trimmings decided to make a small container for storing drills, All the more so for a long time I was going to do it.

To address the issue needed:

Two segments of PVC sewer pipe, diameter 50 mm.
The plug pipe 50 mm.
Circle cut from plywood slightly smaller than the inner diameter of the pipe.
The adhesive (hotmelt in this case).

Still I wanted to use the bell, but at the last moment refused as unnecessary, even though he still got on the first shot.

Go

1. In the initial phase of one of the pipe pieces cut out longitudinally approximately one third of the tube. I did this hacksaw, It turned out fine. The edges of the treated nazhdachkoy.

2. Thereafter nanoshu adhesive on the inner side of one end of the pipe to be cut and pasted from plywood prepared circle, the diameter of the fitting, respectively (Photo 2).

3. Then to the other edge of the pasting pre-trimmed cap on the tube, but here the pipe goes inside it.

instagram viewer

Although used for bonding Melt, Works very well for this purpose second adhesive.

Here, in fact, the entire assembly process and only one small caveat.

If it turns out that the course of the inner tube with a cut too loose, then on the edge of the plywood where the plug can be podmotat several turns of electrical tape.

I am collecting container load of the drill and check how the product is convenient to use.

When closed, it can be stored in any way, even standing, which is very convenient. That is fit in any available space shelves, tables and bags.

If you made a similar design of the larger diameter tube, it further It can be divided into compartments for various small parts. All the details of the assembly in the video below.

Evaluate material andsign upCanal.

ANDit is interesting: