Plasterer slope so as not to muzzle. There is an important caveat

He engaged walls and, in the course window with the caught free cable slope. Two years ago, I had to warm outside 20 mm polystyrene, since few syreli slopes inside. Now there is no moisture, but should still be left in places. So, the customer decided to put a final order. I worked mainly KNAUF (start and finish).

This window sill without plastic, and is located on the landing.

As usual, the first slope primed Ceresit CT 17, that it was done 3 days ago - it is understandable, it does not stop. Also, before putty incised with a knife and spatula tidy excess foam around the perimeter.

On a picture 2 it is clear that the window with the unclosed foam has been around for a long time, since the top it was quite burnt out in the sun.

The most important

And it really is not a trifle. We are talking about the correct application of putty layer on the slope side of the window frame.

zapenennuyu the gap between the frame and the wall - 1.5-2 cm. but starting putty layer should not only overlap it, but still go to the frame 1 cm
instagram viewer
. Well, at least 0.5 cm, so too do sometimes, but if the thickness is impossible to deduce. Thus the total thickness of the layer near the start of the frame in this case, 3 cm.

The picture shows the spatula show which part of the frame must be covered with a layer of plaster.

If the filler layer until the frame reaches only or it is on only 1-2 mm, after some time frames on the junction temperature and the slope appears crack, which starts to blow and. And every year more and more blows. But if the putty go to frame 1 cm, it is:

prevent drafts;
does not give the slope supercool;
fully or partially suspend condensation.

The trick here, of course, makes the external insulation, but when it is not present, then a layer of putty on the slope must not be minimized. Also, if there is no external insulation, be sure to check that with the slope and the good of his close up, as interior helps only partially.

Parties slopes adjacent to the wall, were warped, straighten them with a small rule. Since the thickness is large, the start had to be applied in two layers.

Due to the large gap with the foam under the windowsill had to jot down a bunch and start on the stucco windowsill. There's even another filler used, the PLATO-old start, which is due to the statute of limitations to grasp for 5 minutes.

In the picture above shows how much of the material had to be added to align the vertical slope: Left layer thickens to the top of the right - to the bottom.

Corners on the slopes of the owner decided not to have to align well. After today's two-layered rough alignment window looked. All that influenced produvaemost already done. It remains a little later trim the slope and angles of the start, finish and paint the walk.

Evaluate material andsign upCanal.

ANDit is interesting: