Useful content

RJ45 connector replaced without special tools

click fraud protection
Picture 1.
Picture 1.

Several times asked the acquaintance crimping pliers to crimp a broken RJ45 connector on the cable internetBut the last time was already uncomfortable, so set to work without special tools. Penny bought a couple of new connectors and went ...

What should be done to crimp

From flew connector latch that keeps it in the nest of the router, and something else with contacts not so me.

Together with a broken connector cut wire about 10 cm. I removed the insulation cutting and gently straightened the wiring, which only 8 pieces. Now I see how much comes in and focusing on their location begin to prepare for the new cable connector.

Picture 2.
Picture 2.
Important. Clean the insulation you need no more than 1.5 cm, this is the maximum. If more, the wiring is zazhmet latch inside the connector and they later may povypadali with terminals.

Align on the prepared end edge wires and position them in a sequence, as in the connector cropped (2 photos).

Picture 3.
Picture 3.

And now in a brand new connector slowly looking for some wire until it stops

instagram viewer
. They need to rest against the front wall of the connector. also on picture 3 clearly visible, where it ends the isolation and the position of pressing the latch cable.

Without crimping pliers

First flat wide screwdriver (not sharp) need vyschelknut clip by pressing down on him, like in the picture 4. After that, cable locks and veins will not fall out of the connector.

Picture 4.
Picture 4.

Next, shake veins individually. Here you need to choose a slotted screwdriver at the desired width and thickness of the tip. Tip should be easy to dent into the terminal.

Screwdriver can break down the plastic partition between terminals, so it is necessary to press gently.
Photo 5.
Photo 5.

Above on picture 5 it is clear that the first two terminals are already pressed to the end. They are recessed into the interior of somewhere Slot insulation and 2 mm. And so one by one with each. After completion of pressing the connector is ready! We can only check it by inserting it into the router.

Photo 6.
Photo 6.

A few minutes later I am convinced that all the works, the method deserves attention, although he was not sure that the result will please. All OK!

Evaluate material andsign upCanal.

And it is interesting:

Fillets glued tape, self-adhesive with trimming
How to remove the remains of long-standing foam
A durable connection without soldering wires
Stylish cut a tree from the lights

Stylish cut a tree from the lights

The men, too, are able to make a real designer item with your own hands, even from such a coarse ...

Read More

Do we need more technician. TV made for his wife and thought

Do we need more technician. TV made for his wife and thought

Satisfied spouse to the good weatherThe other day broke the TV, it is not the first freshness (no...

Read More

As original and tastefully decorate your bathroom and make it a memorable interior. 8 unusual solutions

As original and tastefully decorate your bathroom and make it a memorable interior. 8 unusual solutions

Good afternoon dear friends!Who said, that restroom in your home to be a faceless and spineless? ...

Read More

Instagram story viewer