Cleaning the trap under the sink. Master OK
Good time to you, dear visitors and subscribers!
cleaning the siphon - a simple, short, and the right thing. If it is clogged, many think it is better to pour into the sink any miracle solution, and by the time the permeability will be the same, but it is always so.
Not all deposits are fat nature, so some of them are nothing more than to mechanical cleaning, are not deleted. Over the years trash is compacted and adhered so that the solvents do not penetrate fats in their thickness, but only clean fresh upper layer.
This trap I put a half years ago and works of fine. But since the mesh in washing is not necessary, I decided to check how he zamusolilsya. In fact it is prevention. Getting Started!
It does not obstruct anything you need, as long as the tap water is not flowing. Under siphon put an old pot, because when unwinding from it a little, and pour will fall.
The procedure works
1. I reach for the body and the siphon to unscrew the bottom of the flask cap (Photo 1) And give to drain water. After removing the cover, the degree of contamination can be clearly seen. In this case, on the lid there is only decent raid.
2. Now let go of the nuts. First untwisting side that holds the drain corrugation, and then pass to the upper nut that secures the flask screwed to the washing tube. Here, the bulb of the siphon in the hands and see that it has a little bit of garbage (Photo 3a)Huddled into a ball. Another check input state in the corrugated pipe (Photo 3b).
3. All removed parts of the outside and inside of my meticulously in warm water and detergent, using an old sponge. Do not forget to clean the threads and all sealing rings. Here they are black, but there are still blue and red. After "bathing" siphon like brand new (Photo 4).
4. It is also important to make sure that all rubber seal rings whole, especially the most subtle, that stands in the bottom of the flask (5a photo). If he got fat, it may take even vylazit from under cover during reassembly, so you need at this track over the entire circumference.
Quite unfit ring should be replaced by a new, but one can take his place, and the whole thread wound several turns FUM-tape.
On picture 5b it is seencone-shaped ring, which on top of the flask, left inside, I did so, and soaps. If it is you will be pulled out, trace, then to put as it was, and not vice versa.
5. I spend assembly. The sequence is not strict, most importantly do not forget to put in place. After assembly, be sure to check the trap for leaks, especially where the lid is screwed onto the bottom of the flask (photo 1). The result of a good - everything is OK!
The video shows the demolition, then the assembly is already washed siphon.
Put your article assessment, and share your thoughts in the comments.Subscribeper channel, so as not to miss out on something new and useful!
Read more:
Dripping tap or faucet - repair for 30 min. Master OK
Flexible hose: reinforced corrugated or - which is better?
Trimming Wallpaper: makes a perfect butt!
remote control buttons do not work? 15 minutes and everything is OK!