Laying cables in the plinth. Master OK
I am glad to greet you on the pages of the channel of practical ideas!
Like anything complicated, but sometimes such work as the laying of cables in the baseboard is prolonged, especially if you have to lay them somewhat, but still in the same cable channel. Nuances always enough. Some of them consider here.
The cable through the internal angle
If you plan to lay wires in the plinth, the more often it is necessary to do in the course of its installation, and after its completion. Here is just one example of the error (photo 2), due to which had been attached to disassemble the plinth.
As can be seen, the cable comes out of the wall, it goes into a corner, and only then is put in a plinth, and this is not true, as to put it in another plinth from the exit site it will have to be cut. Revised shown in photo 3. I think you see the difference.
When using a plinth connectors, wires can be pulled once installed (photo 1).
Connector - is only a thin strip with a mustache, nothing behind it, so plug the TV cable connector and even internet wires will pass quietly behind him, checked!
Cable through the outer corner
Another catchy moment - holding cable through the outer corner. If external corners with a mounted to the wall foundation type "Crab", then it is necessary to hold the cable straight through it. Usually it provides design "crab". On photo 4 such a case and displayed. You also need to make sure that the cap screws that secure the base of the outer corner, will not prevent to hold the cable. To do this, they need to sink deeper.
4 In the photo on the left can be seen the mounting hole "crab", but the screw in it yet. Serving hat after you install it will put pressure on the cable and prevent close the channel strip.
Cable outlet in the right place
To bring the cable from the baseboard, you just have to cut output in place of the trim cable channel, bend the cable and insert the bar a little further (photo 5). It can be seen that the channel is placed another cable that transits on where to do the same thing for him.
In the course of laying need to gradually tighten the wire, it was not necessary and then pushed into the plinth entire surplus loop and then everything will be OK.
If the article has proved useful, support its Laika.And subscribe to the channel to find an easy way out of difficult situations - SUBSCRIBE.
Read more:
Painting an old, greasy ceiling of PS-tile
And nice cat: ventilation doors in the bathroom
Slopes tiles in the bathroom. Rate it!
Universal canopy of PVC pipe