Installation of a plinth in unusual corners. Master OK

Continuing the theme of skirting installation started in the previous two articles.

I did not think that the installation of any two gadgets have to spend two hours. And before that, in the same time almost all screwed skirting the perimeter and it seemed that vot case this is the end, but then "Painted" with a turn angle of two degrees 130 - 140 and plasterboard projection extending at an angle to the floor and the entire width 4 cm. If it did not help the trainee is not exactly the right!

For images not strictly judge, the best at this stage did not. Yet they are pretty good show, how to get out of the situation when furniture plinth designed only for standard room geometry with right angles.

Big reversal angle

If the angle would be 100 degrees, then put the normal area can be without looking, but most turn spoils the whole picture and bulge bar plinth away from the wall, as it is not cool and bridges. That is why it was necessary a little tricky.

Long took aim, eventually took a sharp knife and

instagram viewer

clipped plastic internal angle of a turn angle accurately, so that it lies against the wall. In the picture set for comparing a corner next to the clipped and was finally established. It can be seen that the wall did not depart and looks fine.

First, like a plinth to make an incision on the back side and bend at the corner, but it turned ugly and unpresentable. So it can only be done at a small bending straight, the angle is not more than 170 degrees.

Ledge obliquely

When the wall bulges in the plane of only 4 cm at an angle, but also at a right angle, to win a "dislocation" is also not succeed quickly. I did not paved outdoor area purchased by the customer, nothing good came of it. When installing at an angle to the floor, he also does not overlap the baseboard along the entire height, so we had to postpone it and think again ...

From what was at hand proved to be the best means of scrap laid linoleum. It then stuck on a ledge. Before that clipped the profile plinth and put on the silicone.

Linoleum on the one hand is pressed against a plinth, and on the other end overlaps the baseboard, forming an angle of 90 degrees with them.

I admit that the decision is not perfect, but it was approved by the owner and taken me on board. However, if you know the best way out of this impasse, share thoughts, I would appreciate that shall try, be sure to write about it.