Why does not the kettle? Master OK
Favorite Kettle longer included? Then we try to do what is possible for yourself. A high probability that the case in oxidized NC contacts.
Only I dare to question repair consoleHow to draw a brand new object - a teapot. It seems that there is more and more difficult, but we will try to do that, you can, maybe you are lucky.
It turned out that the most difficult to repair this unit and understand what in general is very unexpected.
1. I do not touch the stand, take only tea. Find below the 5 screws as much as 3 in the middle and more - 2 at the end, they are a bit rusty even.
2. One screw was very tricky, had to twist it with anything, but got only a pair of scissors.
3. Firmly remove the bottom cover and understand that access to the contacts that closes the power button, even impossible, therefore, I understand further.
4. Before us clam terminals (see. below), which is better to disunite, not to break the wires and it was easier to work with.
5. Also rented button on the kettle. Her legs have to pry and pull to the side.
6. Unscrews bolts that secure the bottom of the kettle to a metal plate to which is fastened a plastic part with the entire filling. Here they are 3 units.
7. Rented as a lid that covers the inside of the turn on the device. It is this: flat black with a step.
8. Otkruchenny disconnect the unit and understand that the contacts still do not get it! I have patience and to unscrew the metal cover. She bolted 3 samorezikami. The picture shows the screws have loosened.
9. As a result, separate the plastic panel with contacts and reserve makers alone.
10. We work with the remaining part. First remove rust from round and flat metal plate, and then turn over the entire unit and looking at a break contact.
11. Contacts in this model two. They are arranged symmetrically. Take nazhdachku or something metallic and slowly we clean the upper and lower contact surfaces.
12. In the picture below you can see, the truth is rather weak, a small plastic rod protruding white. If he quietly rolled and lost, then to work the button is, so when working with contacts, I pulled out the stem, and then re-inserted.
After cleaning the contacts do more does not become, as Kettle gathered into one, poured a little water and... About a miracle! He was involved!
The model differs from the model well, so there are nuances of each disassembly. Contact clean a lot easier if the power button is located at the top of the handle. Then it is sufficient to unscrew only 2-3 screws under the lid will open and full access to the right place. So good luck, my friends!
Please put the Huskies in approval of this review, write comments and join the group of regular readers by clicking on Subscription.
Another interesting channel:
Ventilation transit. A convenient way!
The new trend in the finishing slopes №2. Master OK
Change the valve to the tank. Master OK
He stepped tile. It is, glue or not? Master OK