Reinforced plastic bottle for closing plastic bottles

I'll start with a short history, who are not interested, then get down to the process below. In general, I do not know of what make modern bottle, but they often do not withstand even a small touch of the door jamb or against each other, just to smithereens. Here I still have a few bottles of Soviet who serve faithfully for many years.

Has its own plantation harvests are good and of the spouse does seamer in large quantities. Makes them in the kitchen, I keep the transfer to the cellar on the street. So statistics show that out of 20 bottles I have two sure kotsnu. And just lightly enough to hit them against each other when stacked on a shelf.

If Soviet bottles were allowed to start just a crack, those immediately scatter into small pieces. Butylki most do not mind, I'll buy a new, but very sorry for a snack))

And then came the moment when another portion of cucumbers scattered on the porch, a joyful applause wife, I decided to find a way out and climbed into the Ok Google. Found, there is one man put butylki to cut plastic from a flask of water.

But I went ahead. I have these baklazhek many gather up a few, because they are constantly buying them in sunflower oil.

So now my butylki almost armored. Even if kotsnul, do not fly. If suddenly gone crack, then the contents remain intact. Karoche very comfortable stay.

And so we go. We need to work building a hairdryer, a plastic bottle of 5 liters, stationery knife and two hands. Cut off the neck of the bottle by Maruskin belt and puts forth to the bottle.

It is important that this should be done on an empty container with a full it is better not to risk it. Put the bottle and cut the extra edge boklazhki so that its level was a centimeter below the neck butylki. Cut once, have not yet started to heat the dryer, because too high edge boklazhki not give nice stick round bottle.

Then, overturn bottle put on the neck and begin to blow hot air from the dryer. Making heat uniformly over the entire surface to plastic is not frowned on one side and the other side is not pulled.

Then cut out the bottom of a plastic bottle, otherwise you can not put the bottle smoothly. We begin to blow the bottom of the dryer until it completely takes the form of a glass container. And of course do not overdo in one place not to propalit hole.

Further overturn bottle and repeat the operation with the upper part. Op la and ready, your bottle is now in armor and strength characteristics are not worse than the Soviet, and perhaps even stronger.

From small baklazhek can be made of the same durable carrying case to liter jars.

And by the way, I then realized but next time I will. You can print out a cool label, branded and solder it together with plastic. Write "My zakus" or "Cucumbers from Mikhailovich"))

And of course be sure to subscribe to the feed and zhmaknut husky, and there is nothing you can not have))