Cheap heating for the house, garden, garage with his hands: a ceramic heater for 500 rubles

Often it requires additional heating during winter. Sales have heaters for every taste and budget. But to save money, you can make the device their own hands. The effect will be the same as in stores. How to make your own compact, efficient heater to the country, in the home or garage?

Oil-fired heaters go by the wayside. And the first place is now occupied by the ceramic heaters. They are able to heat a large space and consume less power as compared to the oily brethren.

The cost price of self-made heater around 500 rubles and such sale in the store are from 2500 rub. Heater turns out 250 watts of power.

To work you need to prepare:

• granite tiles 45x45 or 60x60. (The price of 200 rubles.).
• Z-shaped corners,
• Heating Cable 12 K. (6 meters), resistance - 33 Ohm,
• power cable cross-section 1.5, stranded. 3 meters. Plus plug.
• tile adhesive or peskobeton M300-400 solution.

Corners we need to strengthen the heater to the wall. 2 mounted on top corner tile, and the third from the bottom keeper (see diagram below). Tile in our case we use 60x60 cm.

Depart from any edge of the tile 10 cm. Draw a line. Attach the corner, draw the seat mount it to the tile.

Glue on liquid nails (acrylic adhesive), all three corners on the tiles. Withstand day to glue grabbed.

Then immediately (without waiting for grab adhesive) may be applied cable. Cut the cable. Put him on the tile to tile and secure with masking tape. The cable must not be crossed, superimposed on each other. Do something like this, as shown in the figure below:

Acrylic adhesive glue cable to the tile, and the next day remove the tape. Now connect the wires to the network cable.

Next, you need to make the frame of the rack. The inner sides pasted with adhesive tape to glue did not stick to the tree. dolzhka frame advocate for tile 1 cm. That is needed glue or cement layer - sandy solution in a 1 cm.

You can do without frame. You just need to close the solution fully heating cable. Along the edges of the thick layer is not needed - there is no cable:

Put the box, pour the solution and let stand for about 3 days, preferably a week. After drying top betonokontakt applied, the solution does not crack and does not sprinkle on the edges and corners. Mark out and attach to the wall.

Channel RemontDom: SUBSCRIPTION. Please click on the Like - thank you for your attention and we wish all the best!