Drovennik for a bath with his hands. Pouring the foundation for 500 rubles
On a plot of about baths, has a season are firewood. How he could - hid them from the rain and snow. But feng shui of this type no. You need to fix.
After the construction of the front of the fence, yet the weather is warm, I decided to build a small drovennik. Somehow, like that's an option in the form of a pyramid:
Drovennik small size, minimum building materials, does not burden the view at this point the plot. And maybe even give it something unique.
High-grade, large drovennik to be built elsewhere. He will need to store firewood for home furnace. And this, for a bath - that whenever drowning bath does not go to collect firewood across the entire site. Replenish small drovennika, carrying firewood on the truck, but separately allotted time.
In the second part I will write about another important reason - why did you choose such a structure. It will be a life hacking.
Drovennik decided to put firmly on the pier foundation.
Because my drill, which I dug holes for the fence posts - lost relative (let him do the fence), only a few new holes has decided not to buy. We had to dig the pit with a shovel:
Dug a pit, I began to collect the formwork. Formwork for foundation pillars size: 150x150 mm (beam size). Formwork made from scraps of old boards that are used for pouring concrete tape under the fence.
Six holes. Central decided to fill a plastic sewer pipe is 150 mm. It was assumed that half of the pipe take off after casting. But to remove them could not, leave it.
At this point of land with a small difference in height. The upper bars - in the formwork from the bar 50x50 mm. Bottom - board of 150h25 mm. To formwork did not fail in the pits - did stand out of the board. Lasers put everything on the level. Where necessary, cut or spiked soil.
Rectangular arrangement of pillars checked diagonal measurements with a tape measure. The size of the base drovennika 1050 mm (width planks 7) to 2200 mm.
Stuck on three segments of fiberglass reinforcement for reinforcement of poles, piles. The load on the pile is almost no - firmly reinforced, buy steel reinforcement does not see the point. A spa remains from the construction of the fence (bought extra).
He pulled the rope between the corner formwork. On it will be exhibited at the height of the central casing of the pipe. Once again all I rechecked.
Purchased for fixing the beams to the foundation drovennika: rod (pin) 2m M10, washers, nuts - all for bolting to the lumber poles. Angles, masking tape (hide threaded studs). Stretch film - for pouring forms (for decorative plates on fence posts)
I proceeded to fill. Concrete vibrating pokers. It took 2 to 4 mixers concrete buckets (two buckets cement). After pouring inserted pins for securing the beam to the columns. All covered with polyethylene bars.
A week removed the formwork. It was cold that would be gained strength concrete - waited for just such a time. Concrete, which is squeezed under the formwork - brought down the hammer, that would be it for the column is not squeezed frost heave.
Cement, CBC, fasteners, fittings estimated spent about 500 rubles.
***
Read more: Drovennik for a bath with his hands. Installation of floor and frame
Subscribe per channel, introducing it in the browser bookmarks. There is a lot of interesting information.