Peeled edge film from the kitchen cabinets - repair without glue
Kitchen - the center of any home. It is a place where food is prepared, where the family gathers at the table. It would be desirable that the kitchen has always been friendly, and its trade dress are always pleased owners.
People often buy furniture made of particle board covered with PVC film. Chosen mainly by price category, and then only in appearance.
Minus of such furniture is that over time, the film peels off and is seen pressed particleboard.
This occurs for several reasons. The film may peel off at the ends near the oven, an electric kettle, other kitchen utensils, or from moisture. High temperatures spoil our furniture. Another reason - violation of the technology in the manufacture of the facades.
How to make sure that the film does not come unstuck?
Wash kitchen with facades MDF need mild detergent. No need to use powders. There are special. sprays for cleaning surfaces. You can clean the surface of the liquid for washing windows.
Do not place furniture close to heating appliances. High temperature is above 35 or below 10 degrees can cause film delamination. The film leaves in the winter if intensively aired.
Repairs
1 way
PVA can be used or the time to glue the film, but she again exfoliates. And if you often stick, it eventually crumble completely. You can show imagination and use nails with decorative caps. But it does not look nice.
Chips can be removed using melted wax, after solidification nazhdachkoy walk. Then paint over the marker in the furniture tone.
There is a more efficient way
method 2
Glue iron peeled off film and paper. In the manufacture of furniture adhesive composition applied to the substrate and bonded at high temperature. We are using this knowledge and the glue film at home.
The method is suitable for iron with furniture from MDF and PVC film. Heat the iron. Now take a sheet of A4 copier. He was tight and just fit.
Lean sheet in place unstuck film or swollen. Turning off the iron and iron the place tidy. The film is smoothed and again stick to the DSP. Iron well restore a damaged furniture. The result on the face:
RemontDom channel: subscribe, Put the Like - thank you for your attention!