How to make the hallway with his hands. 7 "simple" steps and 24 hours

Good afternoon dear friends!

been dreaming a stylish, concise and functional hall?! A family budget does not allow to implement your ideas to life. No problem!

How about entertaining to pass the time and get a single copy "personal" hallway? As a result - will save money and get exactly the piece of furniture, which will be 100% fit your space and dreams. So today I have prepared step by step instructions for the production hall with a score of 5 points.

I am sure that you would not want to stop there. In fact still need to find a place for a mirror, fasten the shelf for decorative "stuff" and other things, and of course build ottomans for the full set. Tasks are endless, and hence the opportunity to test their strength - are endless!

1.What do you need? Chipboard, LDVP, wooden board, wood panels, plywood, decorative trim (rake), boards of wood, glue, consumables, hooks for clothes and accessories, a pencil and a sheet of paper.

of the tools: Saw, jig saw, pressure gun, drill, screwdriver, tape, stapler, level, putty knife, sandpaper, brush ...

2.Harvesting of the main components. According preformed drawing (depending on the size of the room) to make cuts that will be the main "skeleton" of your hallway. Assembly is more convenient to start from the bench and shelf top. Make them 2 are the same, only with different height. The first design would outdoor bench, a second - separation for hats and accessories. Her place will be the ceiling.

Lock angular side clamp and connect the side panels 4 with screws. Similarly reception place and secure, at the desired distance, the transverse partition inside the finished block.

3.decoration. Wooden slats and diversified and Saw jigsaw size of the lateral edge of each of the working board. It will be easy to attach with glue and nails (pressure gun). Using stapler, close LDVP the back wall of the finished bench.

Do not forget about a similar finish to the shelves, you'll hang up.

4."Grounding". Install the most densely finished design to the wall and secure it with screws. If necessary, after removing the baseboard.

A perimeter open side edges "slide" base plinth, securing it with nails (pneumopistol).

5. body assembly. Previously sawn boards for housing, connect on the same principle as the outdoor bench. Bottom side shelves attach with screws to the sides of the bench. In the upper part of the finished housing to lock the second shelf. Almost everything!

6. Closing background hallway. Pin gun wooden battens in the gap between the upper and lower shelf.

"Targeting" at the interface to make the invisible fastening.

7. Surface for the hooks. With the same air gun, fasten two thin horizontal slats. A first upper flange, a second below. The distance to pick and choose, starting from the things and objects that are going to place in your new hallway. Set the desired number of hooks.

On request, can be painted a support for the hooks, and even themselves. Make a color to match the decorating and get a harmonious and laconic color scheme.

Be sure to collect such exalted hallway Your self-esteem and self-affirmation strengthened.

Previously published material:

Why I did not throw away the table-book. 5 ideas for imitation

IF YOU these tips will come in handy, or liked the article, be sure to click "THUMBS UP" OR SUBSCRIBE ON CHANNEL !!

Thank you for your attention and I will be glad your comments!