Furnace for the cauldron and grill of the automobile disks with their own hands

Winter - it's time to plan for the next construction season or time to gather interesting ideas for garden and plot (if the house is already built). Who does not have a barbecue set, there is an interesting and cost-effective solution for cooking in a cauldron on the fire - a furnace of automotive drives.

Food (e.g., rice or ragout) cooked on an open fire have different taste. Cauldron for these purposes - the best option. A furnace of two car drives - the most simple to the cauldron. Take a look options, how can it be done.

The heat from a furnace heats the entire side surface of the cauldron, and the food does not stick to it only at the bottom, as it happens on an electric stove. Note - in the disc has a recess in the geometry, it is just suitable for installation proved. To cook two discs (not necessary a continuous seam), cut it for firewood and welded legs (but not necessarily).

Some cut out part of the disk for what would be a better fire warmed the cauldron. Cut need a diameter of pre-acquired proved. Little cauldron can fall if not guess with a diameter cutout. If the weld legs and arms to such an oven, you get even more convenient and portable option.

Feet of tubing 40h20 mm. Whatever coal does not spill out of the oven - brewed a central hole in the disk. The holes in the steel disc on its perimeter air left

Some do even grill from the car drive. Kind of not very much, but the function is carried out. Perhaps it is the easiest and cheapest to manufacture BBQ of all. Minimum welding work. Housing purchase and symbolic money (or any shinomontazhke based vtormets). Options, or rather their diameters - what you want.

Grill of the truck drive, such as from ZIL and GAZ. The central part of welded. Welded mesh, coals to avoid spilling and do not block the airflow. Welded legs on the steel rim for stability. If such a high-temperature paint paint and fill the coals, and not all will understand, from what made this BBQ.

BBQ during use. Cut segment in the disk to the width of the grid is not necessary. You can make a cut just below the width of the handle. Well, pick up a grid that would be entered into the drive. And you can put the jumper on the grid of stainless steel. And fry the meat as it is done in barbekyushnitsah or in American films.

This brazier manufacture even easier than grill from the gas cylinder. Who has not seen, you can read an article about this method here

Photos taken from public sources, with Yandex service. Pictures

Subscribe per channel, introducing it in the browser bookmarks. There is a lot of interesting information.