Frequent breakage of doors and windows, as they are repaired

By the frequent breakdowns of doors include:

The door is warped and does not close

First of all it is necessary to examine the loops, such damage may occur due to the fact that loosened the screws that attached the loop. They need to use a screwdriver. If the screws can easily rotate, then it loosened the socket screws in the jamb.

The door can be repaired in 2 ways

a) Choose the screws so that they are more diameter and longer than the old ones. For tightening of the screws should be countersunk make new holes for the screws, it is necessary, because the screws can not enter into the original holes or depressions available under the bonnet of the old screws can conceal large cap size screws. After that, the loop is attached to the door.

b) first twisting the screws. Then, from the well dried oak piece or ash, walnut make jams, their coat with polyvinyl acetate glue and hammer into the slot.

After thin drill (drill must be at a diameter which is smaller by 2 mm than the diameter of the screw) is drilled in each wooden plug guide holes and fasten the loop.

The door is stuck in the top or bottom of the jamb

(shoal - a lateral rack door frame). The door is fixed wedges so that it has been fixed, a little hyping screws, which are screwed to the hinge jamb.

Then make cardboard pads that have a slot opposite the screws and enclose them under the buttonhole plate. Screws screwed back and look, became the door is closed. If required, you can insert a few pieces of gaskets.

But if even then the door jammed, then, try to understand - where in the door jammed. First, carbon paper placed on the floor, but so that the dye side is facing toward the floor. After a few times, try to close and open the door. Where it is stuck to the trail from the blueprint. Then podstrogayte door zenzubel this plane with a knife, which occupies the entire width of the sole.

Sometimes the door jams because of the thick layer of paint, then paint can be scraped off.

Breakage of window boxes

Usually made of wood casement attach identical to that attached to the door jamb. Therefore, the renovation of breakdowns sashes of windows identical to repair the door.

If the flap become loose, you need a loop to score a wedge or make jams of wood and attach the loop. If the glass rattle, then it can be corrected strengthening shtapikami. If the flap is deformed, it is necessary to podstrogat.

If the frame became loose in the corners, then a part of the window sash will be very bad open and close. To buy corners repair of steel. Cover flap, with the help of wedges give it a normal position, and then attach the screws to the corners of the steel frayed corners of the frame.

Channel RemontDom: SUBSCRIPTION. We are grateful for the huskies!