Warm film floor: the installation and the cost of infrared heat-insulated floor

How nice to get up in the morning and walk bare feet on the warm floor. Some reject this way of heating - because of ignorance or negative reviews. Is floor heating and how to make your own hands quickly and simply bad - cover in this article.

Underfloor heating is electric and water. Water embodiment involves heating the water in the pipes, which are located in the floor screed. Other (electric) embodiment where the floor heating is performed by heating the cable or of the heating element with electricity supply.

Underfloor heating film, Infrared. Installation

Choose a wide heating cores and broad carbon heating strips.

On the need to clean the floor lay a substrate. You can use polyethylene foam. The substrate coated with Mylar. This coating conducts heat but does not pass electricity. Substrate foil can not be used for floor heating. Substrate joints need to buy lavsan tape.

It is better not to lay floor heating in places where there is furniture. Therefore, you should immediately think, where there will be a wardrobe, bed, table and other furniture. Thermo film has a small thickness, which is very important for doors.

Roll out the roll face down. On the tape, there are cutting lines. On them and should be cut. Then spread out next to another band. To the band did not disperse, you can connect them with adhesive tape.

The copper strip fix copper clamp. One strip of film clamp located outside and the other inside. Hold the pliers. Is threaded into the clamp. The left contact strip must be connected with the left adjacent strip. The right contact with the right. Presses the contact with pliers.

You must close each contact bitumen coating. Usually all comes to warm the floor. In this way it is possible to hide the exposed wires. Isolate bitumen insulation is necessary, and the end of each heating film strip. That the places where the copper conductor.

Now you need to connect the thermostat. He will control tepmeraturu to be set. He warms up the floor on schedule. Included should be a touch on the thermostat. It must be put under the tape and record on tape. Connect the wires to the thermostat. The manual has a wiring diagram. All wiring is best put behind the skirting board. Stroebe can be made in the floor (concrete) or a wall.

We laid on top of the plastic film. The next layer can be directly finishing (e.g., laminate).

Can be laid plywood or hardboard (3 mm.). A top seal coat - carpet or linoleum. The larger (thicker) sex cake, the more heat needed to warm it.

Per square meter will give about 1500 rubles. Kitchen 6 sq. m. The average in need 9000 rubles. Parquet can not use warm film version. Otherwise the material rassohnetsya.

channel RemontDom thanks for the Huskies and subscription.