Compressor AirMac 60, 80, 120: repair and maintenance

Many users are interested in the compressor (blower) standing inside treatment plant Tapas. Questions are often related problems with its maintenance. And the most popular questions from them.

Why Topas makes a noise?

Compressor operation station Tapas It produces a small drone. Compressor noise level in the normal state is not more than 50 dB, and when the lid is closed it station practically inaudible. If the noise is still significantly different from the original, then you need to open the cover and check if the compressor is in contact with the walls of the station. It is also possible to disassemble the compressor and check whether his damaged membranes (diaphragm) as well as to check the motor frame, and of course all of the compressor mounting connection. It is not recommended to disassemble the compressor alone if not under warranty. Before dismantling the compressor, make sure that it is unplugged.

How to clean the air filter in the compressor

Cleaning the air filter should be done 1 time in half a year.

Procedure:

• Unscrew the screw (Figure 1).
• Take off the filter cover.
• Take off the filter, wash it with clean water and dried.
• Installing the filter.

Substitution AirMac compressor to the compressor of another producer

Wastewater treatment apparatus Topas AirMac equipped with compressors, blowers can be used similar to other manufacturers if necessary. It is important to the performance of coincided compressors (68 liters per minute, 84 liters per minute, etc.). If you put the Chinese compressor - will not work for long. Take the best time-tested AirMac compressor, Hiblow, SECOH. AirMac compressor is equipped with a spare set of apertures (membranes), the purchase check with the seller. If you select other compressor manufacturers directly purchase spare membrane.

 How to change the membrane into the compressor

Armed with a screwdriver, the instruction of the compressor, disconnect it from the supply, take back and can proceed:

• Unscrew four screws aluminum compressor housing and shoot it (Figure 2).
• Unscrew four screws spool cover and remove it (Figure 3).
• Unscrew four screws and the casing aperture (diaphragm).
• Unscrew the U-nut in the center of the membrane.
• Shoot membrane.
• Installing a new membrane on the guide.
• Lock the edge of the diaphragm within the rim, the slots sadite.
• Commit magnet new U-shaped nut and screw (necessarily all good stretch).
• Fasten the diaphragm casing in place with four screws.
• Fasten the coil cover in place with four screws.
• Sets aluminum body and fix four screws.

At this the whole repair of the compressor can be considered complete. Remember, the replacement of the membrane usually occurs 1 time in 2 years. Therefore, if your Tapas rustled like something is wrong, most likely worn diaphragm compressor. Just determine the health you will be able to bubbles from the aeration tanks at the station, if the bubble was less or not at all, then the membrane is worn out and can not supply enough air. Therefore, if the compressor is faulty and does not supply the air, micro-organisms do not get enough oxygen and begin to die. Since dead bacteria station can not provide you with the claimed result in a waste water treatment by 98%.

ATTENTION! Device wastewater Tapas engaged in the processing of your waste. Do not forget that to work properly you need to control the functionality to support the operating status.

Your comments...