Tricks for the home and garden: the elimination of the floor creaking, shelf between the tiles in the bathroom, shower from a bucket, cut slate

Everyone has their own tricks to repair was high-quality and fast. We've put together a few tips that may be useful in their work.

gable

It so happens that snow or rain falls in the hole sheeting. It blows out the snow under the roof. Some take the mounting foam and zapenivayut these places under the roof ridge. It's not very nice, and the foam can squeeze out, raise skate. Sold in stores under the special seal horse trapezoidal sheet, but it is expensive.

There is another solution from the builders. Route a gap (a horse) conventional polyurethane foam pieces.

Shower in the country out of a bucket

Of plastic or iron buckets can make a shower. You only need to make the valve side. A bucket with a cold water supply to the street. The sun heats the water and it will be possible to take a shower anywhere after garden work (bucket hanging on the hook).

By the wall chopped home is difficult to nail bar. To log and timber in contact, and there were no cracks, make convenient device from a ruler and pencil. The line need to drill holes and shape it at one end (as shown below).

Then attach the bar to the uneven surface of the timber. Through the cut timber and it will fit snugly into the rough surface of the timber.

Cutting corrugated slate

Slate characterized strength and accessibility. Therefore, this material is often used in construction. If you cut the slate, the asbestos dust particles will get into the lungs. This causes serious problems, cancer and other diseases.

To avoid these problems, wet slate using wet rags with 2 sides. There will be no harmful dust and cut slate will become much easier.

Screw or screw bolt in EAF

To rectify the situation, first drill a hole and fill it with a little glue. In this hole insert the plastic tube. Now it is possible to screw the screw.

Until the glue has dried, it will play the role of lubrication and the screw is easy to get into the hole. When the work is finished, the glue dries, and will firmly hold the screw and tube.

creaking floor

To solve this problem it is necessary to make a hole in the floor (in places creaking) diameter of 20 mm. They pour cement. Once the cement is dry, creaking floorboard previously would balk at it, and will no longer squeak. Hole repaired and painted.

A shelf

When laying the tiles, do not miss the opportunity to make a comfortable shelf of glass or plastic without attachment. Corner shelf easy to attach to the seam between the tiles. Shelf planted in the seam putty, does not require additional support.

If the tiles fell off the wall in the bathroom, a closet, and there is no necessary glue on hand, there is a way to glue the tiles firmly. Dissolve the foam in acetone. Apply the mixture on the tiles and stick to the wall. Glue Styrofoam quickly grasped, and the tile will hold well. Thus the glue can be glued parquet, linoleum and others. materials.

Channel RemontDom: SUBSCRIPTION. We are grateful for Like!