Bowl made of plastic bottles to replace the broken

Football is a good game, conquered the whole world, and the playground sometimes acts even flat, so it is sometimes necessary to remove the effects of home games, such as broken glass, light bulbs, lampshades, vases, lampshades. It is about replacing broken lampshade homemade today and will be discussed.

In addition to an empty two-liter plastic bottle building will need a knife, scissors, white adhesive tape (this is optional) and LED lamp average power.

Open bottle before work I put for a few minutes in the freezerSo that the air in it cooled down, then pulled quickly twisted the lid and waited a couple of minutes, until the air in the bottle to warm up. So it due to expansion of the air pressure has appeared and it became elastic, which is convenient to use.

For exterior design using white insulation tape, since nothing is more suitable in the home was not found. He wrapped the ring in the middle, and from there went to the turns of the spiral upward. The very top of shook completely. Here we can safely fantasize and with materials and colors.

Next to pierce the bottle used a knife and began to cut with scissors on the edge of the electrical tape. The cut-off state due to soft plastic glue masking tape would be difficultSo I do it in advance.

Top has done similar things. Here it was important not to cut more than necessary, and get exactly the size of the decorative lamp cover, that over the cartridge.

Fixing mustache lamp made of hard spring wire, so we had a bit of bent down to not much pressed to the wall of a new lampshade or deform it.

After aligning the edges of the trimmed bottles had screw in a light bulb in the socket and put a new lamp shade in place. Cartridge standard here - E27.

Light bulb took a thrifty 10 watt, Conventional light bulbs in this case can not be usedAs it is strongly heated and melted plastic.

With a design, of course, I have not turned out perfect, and to be honest not much and tried so this experimental model, a project which can be more work. Overall, however, the result is acceptable. Similarly, another would make an oblique cut bottle and diluted formulation of other shades. But so far so. Job take?

Evaluate material andsign upCanal.

ANDit is interesting:

A friend suggested: sharpening drills without special tools

German silver cleaning water and a sponge. And why do something else?

Three surprises for mounting a plinth on the same object