Make a mini-machine for the manufacture of jewelry with their hands

A few days left before the New Year. After decorating the house and visit the children's matinees drawn to creativity. Decided in haste, as expressed by Hayter, from the g *** on sticks and collect 😊 adapt to cut shapes out of foam. And so it turned out multifunctional, so tempted to share with you. For everything it took me a few hours, and had to spend as much as 90 rubles.

Certainly my experience will be useful to someone at a home decorating class at school or group in kindergarten. And can someone with such stanochkom begin their "business from scratch in the garage without investment." Go.

The foundation

For core using cutting plywood and bars that are lying around in the garage. Plywood is a tabletop and frame bars.

One half of the "table top" fasten stationary second makes the mobile. To do this, fasten it to the bars with the help of loops. In place of the joint edge is cut off or ground off by about 45 degrees. From the side of the fixed part fasten the stand and the horizontal bar to it.

The dimensions are not critical. You can do as someone comfortable. After warming I remained trim foam 100 mm in thickness. Guided by him.

cutting end

For cutting use a heating wire. In my case it Cantal 0.45 mm. Sold in stores that sell electronic cigarettes. At the top of it to fasten the screw with the ring. Thereto was summing the power cord (see above). On the reverse side do "temperature control".

Lower mounting ring is orientable such that the top wire held perpendicular to the table. Under the sink is screwed some screws and pull a wire between them so that it does not overlap. I left Cantal meter 0.45 mm in diameter.

Connect the power wires at different points we handle the load, and thus the temperature of heating torch. The shorter the heated section, the more it heats up.

Powered design from an old computer power supply - 12 V.

limiting stops

On the moving part in a straight line from the filament to make a series of holes. Put on a desk foam piece, and through one of the openings bottom insert carnations. It serves as a rotation axis. So it is possible to cut the desired diameter round billet.

Quickly undercut workpiece size helps rip fence. In the fixed part of the table on both sides to make a series of holes. Coaxially with them makes a hole in the bar, which will serve as a focus. Inserting nails, fix the abutment to the desired distance.

Cutting scraps to use other thin workpiece blank. The spacers between the desktop and the horizontal rod set plywood segment. Distance from the cutting wire determines the thickness of the workpiece future.

Lift table

The movable part allows the undercut edge countertop workpiece at an angle. If you attach it to the axis of the cone is obtained. Lifts the table to the desired height and fix the bar in the same way holes and studs.

I anticipate issues with the environmental friendliness of the whole event. If you choose the right temperature when cutting foam no smoke. Yes, there is a slight smell, no more. Accordingly, the need to work in a well-ventilated area.

It remains a little paint here and get these ornaments. However, the flight of imagination has no limits.

Thank you for reading. If the material was useful and you You want to learn how to use such tools to make different decorations, subscribe to a channel and, of course, put your finger up 👍. To be continued.