As for 5 minutes to make a Christmas tree from foam

Hello, friends.

Looking for Christmas decorations? There is nothing easier than to buy them in the supermarket. But this method is not suitable when you have small children. Absolutely have to do something with their hands. Give free rein to creativity and just have fun. Today make a blank for creativity - Christmas trees.

At work we use a universal cutter for foam. How to make it in a couple of hours, at a cost of 90 rubles, he said in a previous article. If you missed it, watch until the process of making Christmas trees. Like, in the end of this article for a link to stanochek.

Go!))

round billets

We need to make four round blanks: Stand and three tiers of herringbone. We select the appropriate size pieces of foam (or cut out from a large sheet).

Set square billet on the movable table and fix the cutter bottom-stud axis at the right distance from the cutting part. Making revolution around the axis - a circular blank made.

Repeat this operation three times. We get a basis for future firs tiers.

Forming cones

Anchoring round billet axis. We raise and fix the sliding table at the correct height. Making revolution around the axis - cone ready.

In the manufacture of the lower tier of the wire should be cut into a third diameter. In the manufacture of the second - half the diameter. The third - to the middle.

I'm making the cones immediately after the cutting cylinder from the square of (without removing the round billet with the device). We repeat the operation for another two tiers.

Putting cones using PVA adhesive. Wait until the product has dried.

creative blank is ready. We call the children, take the paint, beads, ribbons, and have fun. As he promised to give link on the device. Cut, by the way, it can be anything. To be continued.

Thank you for reading. If the material was useful, subscribe to a channel and, of course, put your finger up 👍.