Frequent breakdowns toilet and Solutions
Before you undertake repairs toilet bowl is first necessary to remove it from the water supply system carefully inspect the shutter mechanism, the water supplying mechanism and place system to connect the descent tube drain.
Noisy toilet in the course of their work
The most common cause of noise of the toilet tank becomes breakage of one of its parts. To fix this trouble, should be attached to the float rubber or PVC tube length of 30 cm. In this way you will ensure the output of water through the tube at the bottom of the toilet tank and toilet bowl will run much quieter.
Leakage conductive hose
If the place of connection of the hose to a tank sprung a leak and gives a leak, it is first necessary to cut off the water, so that it ceased to flow into the toilet to flush. Then you need to carefully examine the place of the joint: may cause leakage occurred because the nut fastening hose and drain the tank, unscrew and to completely eliminate the problem it should just be screwed back to its previous position.
If it is not a nut, it is likely to blame for laying, which eventually fell into disrepair. To replace it with a fully unscrew the hose, insert the new gasket, handle fum-tape and thread the hose back in place, re-securing it with a nut.
The continuous flow of water
If the bowl constantly receives water, it may indicate failure of the membrane, located in the tank to drain. Fix this problem quite a force inexperienced person:
It is necessary to fix the first arm attaching it to the crossbeam, and then rinse water accumulated in the tank.
Unscrew the nut that holds the tube in place of connection to the tank and loosen the nut, which is in the siphon area.
Then siphon must be disconnected from all the adjacent parts.
After that, access to the membrane will open and it can be easily replaced by a new one, and then reassemble the drain mechanism.
In addition to problems with membrane continuous flow of water into the cup it may be associated with damage to the float lever. Here the best option is to replace it with a new, bought in the sanitary department store.
Faulty lever draining
This detail is regularly on the move, so the toilet breaks during operation of the first. His own hands is unlikely to revive, so it is best to replace with a new device that is relatively inexpensive.
Before replacing the need to pull all the water from the tank and cover the arrival of a new. Then completely remove the cover from the drain tank and detach the connector. After this will only remove the column, fastening the tank, and then install a new mechanism for lowering the lever.
it depends clean the tank of the toilet inside, overgrown by deposit and rust.
Channel RemontDom: SUBSCRIPTION. Like for many thanks!