Installed a stainless steel mixer. I didn't like one moment of accident
It's time to change the faucet in the kitchen, our "old man" worked hard and began to let water through from under his shirt. Zhenya was offered a stainless steel apparatus with a flexible spout and two spray modes, she liked it, so they decided on that.
Old appliance
To be honest, after looking at the new device, I was annoyed that there no hard connection (because of the long clamping nut), as in the old one.
On it, I used needles that allow you to connect pipes directly, without using a flexible line in a meth-braid, which, according to experience, often caused leaks. For ten years of such connection there were no problems, and during dismantling I saw that for the same number of years everything would have stood without accidents. But the mixer itself could not stand it.
Installing a new
The new one looked reliable and weighed significantly more than the old one. The very moment and
you will see the nuances of the assembly by flipping through the gallery with a description.The installation went well, I rarely install these, but this is a matter of habit, the only regret is that I had to connect through a flexible hose. I think in time to search chrome-plated copper tubing, this will be a reliable alternative to a rigid connection.
Especially my wife liked the mobility of the spout and the two-jet mode, and what I once made a homemade stand for a smartphone, and the work under the sink was backlit. 😊
Subscribe, share, like, new story soon!