Construction stool with the secret of stability

Remember how you had to put something under the stool or step-ladder legs so that they would not stagger while working, I decided to fix it and not waste time on such nonsense.

Trash support

Today I decided not to carry stones, but to make a support for work, in fact, this is a simple stool, but it will replace a stepladder and a workbench for me, I'm tired of working on the floor and putting what I have to put on.

After dismantling the roof of the extension, I got a bunch of bars, I made them out of them. I chose the height of 60 cm, so I decided to make a step, for this I assembled two legs at an angle, fixed the step to the jumpers. I have tested what is needed, now I will do so that the structure does not stagger on a curved surface.

Fifth leg

Everything is simple here, I drilled one leg, installed two bolts there, and made a through groove in a piece of the bar, which will slide out and secure with nuts through the washers.

I must say right away that the nuts are not a very good solution; it is better to use the lambs instead, so that you do not carry the key with you.

Addition

During the test, one drawback was revealed, it turned out that the chosen leg cannot always participate in stabilizing the stool, or the support with its help is not entirely convenient.

The solution turned out to be simple, it is necessary to make a hole for the bolts on each leg, and then you can rearrange the beam to where it will emphasize the most convenient.