Stand for phone and tablet in 5 minutes
If you are tired of moving mugs, cans and boxes on the table to prevent your favorite smartphone from falling, then I think this simple idea will be useful to you. Let's figure out how to make a phone (tablet) stand in just 3-5 minutes. She will help out anywhere and in any conditions. If you choose a more durable material, then it will serve for a very long time.
To make a stand for a phone or tablet, you need to find a strip of corrugated cardboard or bendable plastic and make a couple of cutouts. In addition, you do not need to attach or glue something to it.
A strip with a width of 4-5 cm and a length of 20 cm is suitable. The larger the gadget, the larger the strip should be. Fold the cut strip in half and make it closer to the precisely aligned edges a couple of oblique cuts to a depth of about 2 cm. In general, so as not to cut the material used too far across.
The incisions are indented from the narrow edge by a couple of centimeters. The angle of the phone in the stand will depend on the angle of the notch.
After finishing cutting, if desired, you can smooth the corners with scissors and make the strip even thinner, in short, somehow refine it. And if everything suits you, then the stand is actually ready. You just need to open the resulting clamshell, put it on the table and install a phone or tablet in the cutouts.
By sliding and sliding the flaps of the stand, you can change the angle of the device and achieve the highest quality picture.
That is, in fact, the whole technology. Even the first time, it will take no more than 5 minutes to make such a stand. Write in the comments if you liked the idea and write your wishes.
Read other helpful materials andsubscribeper channel.
- Why are the joints on expensive wallpaper sometimes so noticeable
- How to make an invisible patch on torn linoleum
- How to connect wires neatly and securely