Explains the builder: why it is impossible and dangerous to gouge walls, ceiling and floor
Sometimes it is required to make new wiring or additional sockets during repairs. So that everything is dignified and not striking, the wires are hidden in the wall, and the recesses are covered with putty.
It must be remembered that the holes in the wall should only be vertically or horizontally. You can't do it diagonally. Exceptions are wiring, where the wall is with some slope.
The maximum groove should be 26 mm in depth and 30 mm in width. It is also required to indent from pipes, batteries by at least 40 cm. Not less than 5 cm from the canvas. (same meaning for gender). From the door 10 cm.
Changing under the socket is allowed in any walls.
Partitions are allowed to be channeled in any direction.
In what cases is it forbidden to do chasing?
The consequences can be dire:
- Cracks appear in the concrete
- The strength of the building is lost,
- There is a risk of destruction of a multi-storey building.
Many do not know that it is dangerous to make recesses in the ceiling of a panel house. A recess in the ceiling or floor is tantamount to a cutter scratch on the glass. The plates contain fittings and it is dangerous to touch them.
It is forbidden to make recesses in internal load-bearing walls (concrete, monolithic, brick buildings). The supporting structure is usually bordered by elevator shafts and stairs. You cannot make depressions in them.
For an air conditioner, it is also not recommended to make a recess in load-bearing walls. Can only be done in non-carriers. If one of the residents of the house notices how the employee makes a line in the load-bearing wall of the building, he can go to the Housing Inspectorate and complain. The inspector will check and issue a fine of 2500 rubles. and will make everything return to its original position.