Useful content

Simple and effective ways to hide the screw head in the wood.

click fraud protection

Cap screws on a wood look is not very aesthetically pleasing, so when connecting wooden parts their possible try to disguise.

This can be done in different ways.

Today, we focus on simple but effective waysWith which can be make head screws virtually invisible.

The first method of maskingIn my opinion, it is the easiest and quickest.

We begin the process of connecting wooden parts pre-drilling a hole slightly smaller in diameter than the screw.

This will allow to further facilitate the process of tightening the screw.

Then Drill 8zenkuem opening in the timber (venturing about a quarter).

Chamfering is necessary to ensure that the screw head is completely recessed into the wood.
Chamfering is necessary to ensure that the screw head is completely recessed into the wood.
Chamfering is necessary to ensure that the screw head is completely recessed into the wood.

AND using a screwdriver, twirl screw.

Once the details are fixed, using stationery knife whittling wooden wedge.

The wedge should come close to the hole.
The wedge should come close to the hole.

The resulting Wedge grease with white glue and hammered into the hole with a hammer.

instagram viewer

The excess part of the wedge saw off via the web and sanded surface.

Fiber wedge should match with the fibers of the wood.

The second way to disguise the head of the screw It takes already over an hourBut the result is worth it.

For its implementation will need to have chisels.

it must be set near the future place of self-tapping fixing and angleBy tapping with a hammer, separating a small strip of wood.

Then, just as in the first case, (only has a bent strip) drilled hole and screwed into screw zenkuem.

Zenkuem.
Zenkuem.
Zenkuem.

Then lubricates bent strip and the recess in the wood with white glue and press them to each other.

Fit and carpenter's glue.
Fit and carpenter's glue.

Top put a bar on which the previously pasted adhesive tape and fix the clamp.

It can be used as well for the clamp clip.
It can be used as well for the clamp clip.
Scotch tape is stuck on the bar to prevent bonding parts from bar.
It can be used as well for the clamp clip.

After the lapse of hoursremove the clamp and otshkurivaem sandpaper glued surface.

As a result, the junction is obtained practically imperceptible.

"We are selling the dacha"

This year I changed the fence separating our site from the alley. And you know, I immediately fel...

Read More

What is the resistance of zero resistance and what it is

What is the resistance of zero resistance and what it is

Repair or simply studying the cost of a product (often foreign), you will never run across a resi...

Read More

How to make a reliable and durable soft otmostku

How to make a reliable and durable soft otmostku

It is difficult to overstate the importance of the blind area, especially in areas with high grou...

Read More

Instagram story viewer