How to easily return to the place of a depressed panel PVC indiscriminately across the skin.
plastic panels are budget alternative to tile so pretty oftenused for decoration bathrooms and toilets.
Often, in addition to price, the choice in favor of PVC panels are not unimportant role played by easy installation.
Quite often, handyman independently produce cladding plastic panels without the help of professionals.
And not surprisingly, then we have to correct mistakesThat occur during operation.
This is what happened in our case.
PVC panels were mounted on the frame, and stiffening rib (Unknowingly or to save) It has not been established.
As a result, it was enough one awkward movement and panel going inside, forming an unsightly gap in the corner.
Since the location of the defect is in the zone of constant contact with water, it was necessary to urgently address the problem.
Completely disassemble trim did not want to, because it is troublesome and long.
Then they decided to correct the defect with the help of available funds. It turned quickly and at virtually no cost.
First thing Curbing tape removed and just below the bath level made the cut using stationery knife.
Then have regular direct suspension and bent at an angle about 90 degrees.
Then poked the curved suspension into the incision and slowly pulled themselves.
As a result, PVC panel quickly into place.
But this was clearly not enoughSince the stiffener was not under the panel and it could again at the next bend easily hit.
Then they decided to fix the panel on the inside.
For this using a power screwdriver We drill a hole in panel PVC and filled inner space of the mounting foam.
Then fillets tape and pasted defect is gone.