How quickly and accurately adjust the board to the log wall.

When decorating the walls of log house or a bath is almost always a need to fitting themplanks, boards or other building materials.

Process this is usually take a lot of timeBecause the log log have different degrees of convexity and mark them not so easy.

But this does not mean that this must be tolerated.

Solve this problem It may be enough just. How?

Consider the following.

Speed ​​up the adjustment process board to the log wall, you can use homemade copier.

Make it simple.

suitable for the manufacture of any wooden rectangular die. This can be a piece of wood, a piece of board or even a ruler.

In our case we used a scrap of plywood.

Using a hacksaw saw off a piece of rectangular plywood. After which one side of the die do tip.

To this end, a hacksaw saw off the extra portion of the die at an angle.

On the other hand dice using a power screwdriver drill hole.

On this production of finished devices and can be proceed directly toApplication Markup on board.

To this end, the board puts a mark up to the log wall and puts her homemade copier.

Important! Homemade copier should be strictly in a horizontal position and mark up board in the upright position.

The opening in the insert copier pencil and We carry it in gently along mark boards.

Wherein pencil On the desk draws a line, follows the contour of the log wall.

After that, there is only on the road marking to saw off the excess.