Install handles in interior doors with their hands. Step-by-step instruction.
Setting the pen is the final step in the installation of interior doors. This process is responsible and important, because of the correctness of embedded hardware ultimately depends on the overall appearance of the interior door.
Therefore, in order to establish the handle with your hands should know about and to observe the correct sequence of installation steps. On them will be discussed below.
In recent years, increasingly found the door leaf with the lock already embedded. It is for this door and look at the installation process handles.
The first step is embedded unscrew the lock and extract it from the web.
We are putting a lock to the door leaf and a pencil on both sides of the door marks the place where the handle will be installed.
By striping drill hole using a drill bit diameter 22 down.
To avoid deformation of the web in the process of drilling from the opposite side of the door, you must first drill a hole on one side and half, and then, in full, on the other.
Then install the lock in place and insert the pen into the drilled hole.
Then, fasten the handle to the door leaf by means of the screwdriver.
Then fix the hex knob and screw cap.
We start manufacturing mating latch. To do this, you must close the door and use a pencil to put markings on the door frame.
Then putting a "otvetku" draw out a pencil and using a drill make a recess and align the edge of a chisel.
It remains only to tie "otvetku" to the door frame.
That's in the correct sequence, you can own hands to install a handle on interior doors.