Mandatory verification of power before starting work

Probably will not find such a house where there is at least a well or drill grinders. At the enterprises to work with the power permitted by specially trained people who have passed instruction, and, as required, before each use of the tool must perform his check.

Of course, no one at home does not make you a tool to check before work, but still need to comply with certain safety requirements. On them will be discussed in this article. So, let's begin.

Visual inspection tool

If you decide to work a little, and his drill ponadelat bunch necessary holes in any workpiece, then before you start to work, you need to perform several actions.

The first thing you need to carefully examine the drill. The supply cord must not be damaged areas, that is, the insulation must be without flaws.

The fork must also be whole without defects and should be a standard network performance.

The main body of the drill should be no chips, dents.

After visual inspection of the drill is connected to the network and checked idling. In this case, if the verification of the idle-round light appeared on the collector or smell burning insulation, heard an odd (non-specific) sound or vibration, such a drill to use it is impossible.

If a visual inspection did not reveal any apparent defects, then you are ready for immediate use of power tools.

Safe working with power tools

So, now for the safe operation of the workpiece must be secured and you can start drilling.

If you need to be drilled, for example, in the wall of your home, remember an important rule: Drilling with ladders and stepladders are strictly prohibited. Do not ignore this rule, they say, I'm only one hole needs to be done, that terrible will happen. With this approach seriously injured very easily.

If you decide to work grinder, a visual inspection is carried out in the same order. Only when working with angle grinders necessarily need to use safety goggles. Without them, do not even attempt to operate the power tool.

Clothing of the power tool should not be too constraint, but not hang like a hoodie. body posture should be natural and stable as possible, and when working with angle grinders need to choose a position that, when the likelihood of rupture disc is not to be overwhelmed by shrapnel.

If the work is allocated a large amount of dust, the use of a respirator is necessary.

After the work be sure to remove the power cord from the outlet, and only then proceed to the substitution, for example, a drill or a disc.

conclusion

Remember these rules and follow them strictly and then work with the power will be the most secure. Like this, then vote it Like. And thank you for your valuable attention!