How to use the terminals WAGO

In carrying out the wiring in the house, should be particularly pay attention to the connection of wires in the junction box. According to RB in distribution boxes acceptable to use: twist followed by soldering, welding with subsequent twisting, terminal blocks and clamps. In this article, we will discuss how to use the most common terminals WAGO.

Disposable terminals WAGO Series 773 and 24773

Such terminals are collapsible and are intended for connecting single-core copper and aluminum wires. discern how WAGO series connector 773 for a conductor it is very easy:

Since copper conductors inside the terminal have special filler (paste). And the terminal housing has a color design.

A connector Vago compound for aluminum conductors, is a special content that removes and prevents further formation of the oxide film. The outer housing has a gray or black color.

Connect living is very simple. For this purpose, the tool is removed a certain insulation length. By the way how much you need to clean up the mine to determine very easily: each terminal has a special measurement, wherein said stripping length.

Then, the stripped wires are simply inserted into the connector until it stops. All the connection is ready and do not need to perform any additional steps to isolate the connection conductor.

Note. Connect WAGO connectors and can be flexible conductors only need to pre-pressurize the wire ends.

Some experts claim that the implementation of such terminal connection can be "gently" to disassemble and then re-use. So, so do not be in principle.

During the disassembly of such a compound may be damaged internal pressing mechanism and re-assembled compound may be heated (due to poor contact), which can lead to negative consequences.

Reusable terminals WAGO Series 222 and 221

Perhaps, these series are the most popular among artists because of its versatility. Through such terminals may be connected as a stranded copper wire and the single core section to 4 square millimeters.

The connection process is as follows:

We clean the wire to required length (the correct length is indicated directly on the terminal housing);

Squeeze the levers on the terminal itself;

Inserting the stop stripped wire and omit levers on terminal.

All our ready mix thoroughly.

In principle, using a series of terminal blocks 222 and 221 It can be connected and aluminum conductors and even make the connection of aluminum and copper, but you have to buy a special paste and fill it yourself interior region of the terminal block.

Terminals Series 224

This series is specially designed for the connection of aluminum and copper conductors. Since on the one hand the connector is filled with a special paste for removing oxides with aluminum conductors, and on the other side of the clamp CAGE CLAMP, wherein securely fixed as solid and stranded copper wire.

The connection process is the same as described above.

conclusion

Terminals Vago - ideal for mounting lighting lines and lines with low load. And these connections will be long enough, the only condition - is strict adherence to the instructions. That's all I wanted to tell you about how to properly use the terminals WAGO. If the article was useful to you, or are interested in, you will appreciate it Like. Thank you for your attention!