The sequence of installation of interior doors. Common installation errors

When purchasing a new apartment it is necessary to repair the internal and finish. One of the types of work is the installation of interior doors.

When installing doors should comply with certain rules, not to make mistakes that lead to poor aesthetic appearance. To assemble the door and mount it properly, you must observe the following sequence:

- It is necessary to manufacture the door frame, which are acquired carton blank and casings by color matching with the door (plate).

The box is manufactured as follows: first workpiece is cut by the width of the door opening in the wall. Next, cut off the workpiece side length equal to the length of the door plus 18 mm. Allowance needs to the installation distance formed between the doors and the floor 12 - 15 mm. Door box and an upper strip 3 - 4 mm.

Cut-out must be done on the profile blanks.

Next door width is measured, and the size of a pencil marked on the top risks procurement plus 6 mm. This allowance of 3 mm. on each side, so that the door is not clamped in the box is opened and closed.

Then, the workpiece presses the side of the upper workpiece risks and are fastened with screws for wood 50 - 76 mm. The width of the box again vymeryat laying by the door to the box, the controlled gaps of 3 mm. from each side. All these actions are performed on the floor for convenience.

- Layout and installation of loops performed on the floor where the risks are made in pencil on the box and the door leaf, where will be attached themselves hinges that are screwed at a distance of 25 - 35 cm from the top and bottom door. Loop itself is applied and marked with a pencil its length and width.

Then chisel recess done by counting how the hinge on the box and on the door, a depth equal to the thickness loop minus 1.5 mm., but no more, otherwise it will be spoiled by the appearance, and the door will be skewed and poorly open.

We should not forget that the loops are right and left. Therefore, you need to decide in advance - in which side will open the door and acquire the corresponding loop. The hinges are screwed with screws from the kit to the box and the door.

- Installation of the box is made from the removal of the doors and hinges. The assembled box is placed in the hole in the wall and clamped it pegs or wooden cubes. Verticality controlled level.

Further, in the place where will be the loop hole is drilled and screwed dowel - screws to securely hold the box in the wall, and the wall plug hat was not visible. Dowel screws do not need to be screwed in full view of the box, otherwise the whole view will be spoiled.

On the opposite side mount plugs are not necessary. Next screwed hinges, and the door hung. Again vertical installation shall be verified, and the space between the frame and the opening is filled with foam. After drying the foam, the excess trimmed, and special studs nailed trim, which should not be nailed or bolted with screws, as it is very spoils the appearance.

After completing all of these conditions, the door is securely installed, and look good.

p.s .:My HouseHe is trying to give you the most important, useful information.subscribe to the channel - in front of a lot of useful and interesting information!