Ventilation in the bath: simple and effective. ready-made solutions
What is the ventilation in the bath. Ready-made schemes. Calculation of ventilation. Installation of ventilation in the bath
Without good ventilation in the steam room of the pleasure of the bath will not get, and people who can not boast of good health, walking in a bath at all dangerous. In this article, we describe how to make the ventilation in the bath, and dismantle "classics without air ducts" how the steam room ventilated with our ancestors and how it might look in a modern solution.
Content
- Volley ventilation in the Russian bath
- Do we need additional ventilation holes in the Russian bath
- proper ventilation device in the bath with his hands on the experience of the participants in our portal
Volley ventilation: Proper ventilation in the steam room
The classic Russian bathhouse usually two ventilation circuits have been used:
- volley airing providing sufficient air during hover;
- ventilation to dry steam after use.
Volley ventilation through the open door and window. We emphasize: we are talking about a wet steam room, a sauna instead.
I build for themselves
Member FORUMHOUSE
I had to row with the customer and insist that the wall thickness of 500 mm was cut opening for the window.
To obtain Air for breathing in the steam room, the window quite close to the regiment and the door to the dressing room. The window and the door should be opened between sunset while we rest. Then we go back to the steam room, close the window and the door and again soared.
To dry steam to make it a small air holes (there are different options: some are doing it in the far corner of the ceiling, the other, on the contrary, under the regiment). After use open baths:
- This small air holes
- window in the washing or dressing room.
This creates a flow of air that ventilates the room and takes out the moisture.
The user with the nickname FORUMHOUSE Nomad Ventilation in the bath is made as follows: air flow – a furnace firebox, exit diagonally to the ceiling. Usually all steamed with a closed hood, but sometimes it open, "if not steamed Extreme", and in this case, natural ventilation works.
When you want to refresh the air in the sauna after several passes, hood opens into the heater loading dose splashing of boiling water.
Nomad
All the old pairs of knocks on the window-hood. After that little wave to the doors, creating an additional stream, put a new wormwood, close the window, and a steam room - as good as new, as if there were not soared.
Method "grandfather"
There are interesting and come down from our ancestors' way of airing bath which EsKor, member of our portal, he saw in the bath, "one gray-haired grandfather." In this bath only specially made ventilation means has an outlet in a meter from the floor, under the regiment. What is the meaning of such a vent? It was found that the silver-haired grandfather "refreshing" the air in the steam room is almost the same as NomadOnly previously prepared ice bucket with water and poured it on flanges or a moment before, or immediately after the shock was charged into the heater of water dose.
EsKor
Santa clarified that the cold water, which falls on the floor with the shelf, to itself pulls down the steam and it prihvatyvaet with stale air and flies to an outlet. No mystery, the physics of the case explains well.
The cold water cools the steam condenses, the pressure drop causes increased inflow of air above the layer of steam, and steam literally falls from the ceiling.
It is clear that this method is not suitable for the dry air baths and steam rooms with a hollow floor and the lack of drainage.
Various schemes ventilation Russian bath
Let us examine how such a ventilation system on the examples of several baths FORUMHOUSE participants.
That is our party room with the nickname Vasisdas.
Vasisdas
The concept is simple! Oven stove, door, window, and solid wood. Learn how to use it - a trick.
How to make a window in the steam room: glazed facade from the bath, ventzazor in wall thickness of the cake, from the steamy window decoration. This allows you to avoid unnecessary heat loss and simply beautiful.
Our member with the nickname I build for themselves small room Steam-washing, 2.5 2.1 and 2.1 m in height.
The ventilation system includes:
- window at the shelf 300x300 mm for the frame, itself opening 200x200 mm;
- the air holes in the upper crown of the ceiling 150x150 mm;
- the air holes in the floor under the regiment of 150x150 mm.
Upper air holes always closed, open it only to dry steam after use. Also, sometimes our user opens it to create a more gentle treatment for his wife and daughter.
During hover all the holes closed. The height of the window is chosen well, the heat of the steam is not blown out.
During the guy uses two types of ventilation:
- simple ventilation: come out of the steam room, you open a window and leave the door ajar.
- rapid ventilation through a window in a steam room and a window at the regiment.
For drying, steam room open all the vents and windows.
I build for themselves
Air from outside changing room through a window is on the floor of the lower air holes under the shelf (skvoznyachok), even partially heated by hot furnace and lying above the upper produhi regiment. Under the floor of a draft from the air holes in the base. In winter, at a time of soaring I close them.
These "old ways" air baths, without air ducts everything, our user considers justified and it is sufficient if the thermal capacitance of the furnace.
Here's how to construct ventilation in the bath of our participant with the nickname Mikhailovich Titov. Inflow is made through an opening in the side wall in a half-brick.
If you look from the street, it looks like this.
Branch down to which leaves condensate closed screw cap. Input from the washer is made under the stove.
During the construction of baths member of our portal with the nickname Shagav attached particular importance to the ventilation. In the common room, he made a forced ventilation (one supply opening and two exhaust), and the pair made natural.
If desired, the air in the steam fed from outside - in the base are filled tube passes through the furnace stones corrugated stainless steel. It opens and closes valve.
Five exhaust vents are made at different levels and in different walls. Release and removal of air in steam is adjusted in accordance with the needs.
Shagav
When I want to succumb to the park - all close (like a lot of steam), and behind the ventilation open again - everyone is happy.
Several holes in the exhaust steam can solve conflicting objectives, conducting the flow of fresh air and exhaust air.
Shagav
Ventilation block to succumb to the park and easy to open, to restore favorable conditions again.
As the owner of the bath, the most important thing - to prevent the situation where the cold air reaches the floor of the steam room.
To avoid this situation, he joined the influx of corrugated pipe made of stainless steel - many call this reassurance, but the master was something that counted.
Ventilation works fine, and a steam room to breathe easy.
conclusions
A simple ventilation system in the bath, without channels works perfectly with the proviso thermal capacitance furnace. If we talk about the Russian bath, the air flow required for a comfortable stay in the steam room, sufficient ventilation volley through the window and the door. Additional opening under regiment allow to dry bath after its use.
All ventilation openings in the steam room must be equipped with dampers, which if necessary can be opened and closed.
Ventilation is good when you can manage it!
On FORUMHOUSE you can read about installation of ventilation in existing bath. We recommend that you action-packed and somewhat provocative topic: volley ventilation in the Russian bath - one for all peoples. Read our article about the pros and cons built-in bath. Learn about the main types and characteristics of baths. Also see our video "The microclimate in the steam room. Choice of bath furnace under the desired condition».
Subscribe to the channel! Join FORUMHOUSE!