Laying the tiles in the hallway on the floor step by step with photos

This corridor was made screed quality - without fluctuations, sags, and other defects. Therefore, we begin to lay floor tiles. Tile was selected 450H450 mm. With this format tiles and flat screed, it was decided to lay the tiles using the tile alignment system (AEP) under the comb 8 mm.

It is important to put right the first row of tile. To do this, from the wall in the corners, it was given a mark on the tile width of the laser beam level giving between the labels and check whether our tile goes everywhere. Embodiments could happen due to various wall curvature, but in this case I lucky and the limit deviation was about 5 mm, respectively, in the first row to trim the tiles is not necessary, and the resulting backlash in 5-7 mm easily hidden after installation of floor plinth. We put the tiles on our markup.

Puts the next series using the SVP. This system eliminates the risk of coarse transitions in the joints between the tiles, by squeezing the clamps.

At the same time, tiles often has a convex or concave shape of the front surface, so without SVP tiling process is would be more complicated.

The first day was laid tiles without cutting, respectively, was such a picture.

The next day we bring down mounting SVP and clean the tiles laid on the adhesive residue.

Also reports trim.

When all the tiles laid, proceed to grouting. To do this, fill the joints with a rubber spatula, held for about 15-30 minutes and blur the seams foam sponge.

The next day, all the stains are removed with a dry cloth.

Subscribe to the channel, the only way you will be informed of new publications - in front of a lot of new and interesting information!

p.s.: We try to give you the most important, useful information. If you have been interesting and helpful place "like".