Making the simplest motor of the battery and magnet

All we are ordinary people and we want to relax the field working day and relax a bit. What if our leisure time to spend with you interesting and informative, and even our loved ones to please outlandish interesting toy. In this article I will tell you how to collect the elementary motor of several pieces of wire, batteries and permanent magnet.

Cooking stuff

To assemble our drive we will need:

1. The battery is the most common one and a half volts

2. Holder. It can be taken from any broken toys on batteries. If it's not, you'll need two large paper clips, or two pieces of bare copper wire with a diameter of 1.5 square centimeters and a length of 15-20.

3. Small magnet suit absolutely any. I used magnets from conventional magnets on the fridge.

4. The lacquered wire insulation. Ego can take on any spoiled coil of the electric appliance. You will need about half a meter of the conductor. Also, you need 30 cm of bare wire, the aforesaid can be easily obtained to cut one strand copper cable.

The same may be needed: scissors, tape or electrical tape.

Getting to the collection of our drive

So, all that is needed for the production of our with you a mini-prepared engine, now let's start its assembly:

First we need to make improvised coil of lacquered wires. To do this, we take our lead and we wind between 10 and 15 turns, if you have a wire thickness of 1 square and smaller. I have also been available only lacquered wire 2.5 square, so in my case was enough, and 4 turns. That the coils have turned out more or less equivalent, it can be used as a drum penlight batteries.

Once we formed the required number of turns of the coil to remove our batteries and leave both ends of at least 5 cm wire.

Next to our reel has not collapsed, the free ends of the wrap around the bay as shown in the photos:

Then sticking the ends need to clean up from the varnish. To this end, a sharp knife scrape off the paint on both sides.

So, our reel ready. Now you need to make the retaining device. To do this, take a paperclip or piece of uninsulated wire 10-15 cm long, and makes him the following construction

Next to the poles of the battery fasten our freshly made here holders in such a way

Next, put our magnet (I had to add a second magnet as a single frame does not want to work) in the middle of the battery, and the coil is threaded into the ears.

After that, we attach the coil rotational momentum and oversees the work of the newly assembled motor.

Attention. During operation, the battery is beginning to heat up, so be careful. After completion of the experiment, remove the coil and allow some time to cool down battery.

Why am I not running

You did everything as described, and you have the engine is not turning? There can be following reasons:

This is very long holders have turned. Just shorten them so that the coil was as close to a magnet.

Insufficiently reliable contact our platforms with the battery, just push them harder and further Wrap tape.

Check out these points and you all should work.

This simple toy you will not only amuse yourself and loved ones, but also be able to spark the interest of your children or grandchildren to physics. Thanks for attention.

Dear readers, if you liked the new column, and you want to on the channel was more like, you will appreciate this stuff Like and repost to any social network. So I understand that you're interested in it and I will train more similar material. Attacks do not forget to subscribe to your channel ENERGOFIKSIK.